Abstract

We propose to implement a 2-channel optical-time-division-multiplexed (OTDM) system for short-reach optical interconnects by using a sinusoidally modulated light source instead of a complicated mode-locked laser as an input pulse source. In this system, the OTDM signal is obtained by bit-interleaving two optical return-to-zero (RZ) signals generated by using the sinusoidally modulated light. We operate these RZ signals in the orthogonal in-phase and quadrature domains to avoid the unwanted beat components. After the transmission, the OTDM signal is detected by using single photodetector, and then processed by a 2 × 2 multiple-input multiple-output equalizer. For a demonstration, we generate 150-Gb/s OTDM signal operating in the 8-level pulse-amplitude modulated (PAM-8) format by using commercial LiNbO 3 Mach-Zehnder modulators and transmit this OTDM signal over 1.9 km of the standard single-mode fiber (SSMF). In addition, we fabricate the proposed OTDM transmitter in an integrated silicon-photonics chip and use it to demonstrate the transmission of the 64-Gb/s OTDM PAM-4 signal over 2.2 km of SSMF.

Highlights

  • There have been growing interests in the highspeed optical interconnects operating at >100 Gb/s/λ to cope with the rapid expansion of data traffic [1]–[7]

  • SUMMARY We have proposed to overcome the bandwidth limitation of the optical modulator by using a simple OTDM technique

  • The potential problems arising from the use of the sinusoidally modulated input light, such as the low extinction ratio (ER) and crosstalk between channels, could be mitigated by using a simple 2 × 2 multiple-input multiple output (MIMO) equalizer at the receiver

Read more

Summary

Introduction

There have been growing interests in the highspeed optical interconnects operating at >100 Gb/s/λ to cope with the rapid expansion of data traffic [1]–[7]. If we assume that the number of the OTDM channels is limited to two, it would be possible to realize the OTDM transmission system by using a simple sinusoidally modulated light source instead of a mode-locked laser as an optical pulse source.

Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.