Abstract
The “separable” uncertainty sets have been widely used in robust portfolio selection models [e.g., see Erdogan et al. (Robust portfolio management. manuscript, Department of Industrial Engineering and Operations Research, Columbia University, New York, 2004), Goldfarb and Iyengar (Math Oper Res 28:1–38, 2003), Tutuncu and Koenig (Ann Oper Res 132:157–187, 2004)]. For these uncertainty sets, each type of uncertain parameters (e.g., mean and covariance) has its own uncertainty set. As addressed in Lu (A new cone programming approach for robust portfolio selection, technical report, Department of Mathematics, Simon Fraser University, Burnaby, 2006; Robust portfolio selection based on a joint ellipsoidal uncertainty set, manuscript, Department of Mathematics, Simon Fraser University, Burnaby, 2008), these “separable” uncertainty sets typically share two common properties: (i) their actual confidence level, namely, the probability of uncertain parameters falling within the uncertainty set is unknown, and it can be much higher than the desired one; and (ii) they are fully or partially box-type. The associated consequences are that the resulting robust portfolios can be too conservative, and moreover, they are usually highly non-diversified as observed in the computational experiments conducted in this paper and Tutuncu and Koenig (Ann Oper Res 132:157–187, 2004). To combat these drawbacks, the author of this paper introduced a “joint” ellipsoidal uncertainty set (Lu in A new cone programming approach for robust portfolio selection, technical report, Department of Mathematics, Simon Fraser University, Burnaby, 2006; Robust portfolio selection based on a joint ellipsoidal uncertainty set, manuscript, Department of Mathematics, Simon Fraser University, Burnaby, 2008) and showed that it can be constructed as a confidence region associated with a statistical procedure applied to estimate the model parameters. For this uncertainty set, we showed in Lu (A new cone programming approach for robust portfolio selection, technical report, Department of Mathematics, Simon Fraser University, Burnaby, 2006; Robust portfolio selection based on a joint ellipsoidal uncertainty set, manuscript, Department of Mathematics, Simon Fraser University, Burnaby, 2008) that the corresponding robust maximum risk-adjusted return (RMRAR) model can be reformulated and solved as a cone programming problem. In this paper, we conduct computational experiments to compare the performance of the robust portfolios determined by the RMRAR models with our “joint” uncertainty set (Lu in A new cone programming approach for robust portfolio selection, technical report, Department of Mathematics, Simon Fraser University, Burnaby, 2006; Robust portfolio selection based on a joint ellipsoidal uncertainty set, manuscript, Department of Mathematics, Simon Fraser University, Burnaby, 2008) and Goldfarb and Iyengar’s “separable” uncertainty set proposed in the seminal paper (Goldfarb and Iyengar in Math Oper Res 28:1–38, 2003). Our computational results demonstrate that our robust portfolio outperforms Goldfarb and Iyengar’s in terms of wealth growth rate and transaction cost, and moreover, ours is fairly diversified, but Goldfarb and Iyengar’s is surprisingly highly non-diversified.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.