Abstract
AbstractAn experimental study was carried out with the objective of comparing the critical conditions for the onset of gross extrudate distortion, usually called melt fracture, in capillaries and slits. Narrow and broad molecular weight distribution polystyrenes as well as low‐ and high‐density polyethylenes were used. The onset of melt fracture was observed to take place at higher shear stresses in slits than in capillaries. It is argued that the flow‐average value of the recoverable shear strain should be used as the criterion for the initiation of melt fracture.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.