A comparison of JKR-based methods to analyze quasi-static and dynamic indentation force curves

Abstract

The Johnson–Kendall–Roberts (JKR) theory of elastic contact, extended to take viscoelastic effects into account, is used to evaluate work of adhesion and modulus of elastomeric films. In this paper, we present a comparison of five approaches to analyze quasi-static and dynamic JKR force curve data obtained using instrumented indentation. The load-displacement experiments were performed using a 200-μm radius borosilicate glass sphere against poly(dimethyl siloxane) (PDMS). By applying a small oscillation to the tip during indentation, dynamic stiffness vs load data were also obtained for frequencies between 25 and 160 Hz. Direct curve fitting as well as simplified 2- and 3-point analysis methods were used to compare modulus values obtained from load-displacement and stiffness-load data. Fit methods not requiring determination of the initial point of tip–sample contact (“zero” displacement) provided modulus values closest to those obtained by direct curve fitting. The dynamic stiffness-load data revealed a frequency dependent modulus; load-displacement measurements obtained simultaneously were consistent with the relaxed, or low-frequency, modulus of the PDMS sample. These experiments demonstrate that both the frequency dependent and relaxed modulus can be obtained from a single experiment.