Abstract
In more than 80% of the worldwide photovoltaic (PV) modules, mostly very fragile and 200 μm thick, crystalline silicon solar cells are encapsulated into ethylene-vinyl acetate (EVA) foils, which bond the module components together, provide physical protection, electrical insulation and a barrier for moisture ingress. The understanding of what can happen with EVA during its transport, storage and lamination process is necessary to optimize the quality of the PV module for its long exposure to outdoor weather conditions. Achieving a proper cross-link density of over 70%, it is essential to overcome the cold flow of EVA and to make the module durable. In this work, the feasibility of the use of differential scanning calorimetry (DSC) compared with the solvent extraction (SE) method by toluene were evaluated in order to provide structural information on the EVA curing kinetics and the cross-link density. DSC tests were performed on a DTA DuPont1600 tester. The temperature range for the test was from −50 °C to 200 °C, with the heating rate of 10 °C/min, and the endothermic and exothermic peaks were evaluated. Toluene solvent extractions were performed on the same set of samples that were analyzed by DSC. The measured cross-link density shows a direct dependence on the pre-lamination conditions of EVA, which is in good agreement with the data obtained with the DSC method.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
