Abstract
In recent times, aerospace, chemical industries and nuclear plant have usually used Inconel 718 alloy because of its excellent mechanical and chemical properties at elevated temperatures. It falls under the category of difficult-to-cut materials due to its high toughness, poor thermal conductivity and high hardness. The set-ups for electric discharge drilling (EDD) and powder-mixed electric discharge drilling (PM-EDD) were developed, and experiments were conducted on them separately. This research shows a comparative study amid producing holes by EDD and PM-EDD in Inconel 718 alloy workpiece with copper tool electrode. SiC was used as an abrasive powder because of its better thermal conductivity in order to get properly mixed with dielectric in a separate tank. Output response was assessed in the form of material removal rate, under the influence of discharge current, duty factor, pulse-on-time and tool speed, as the input parameters.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
