A comparative analysis of corrosion assessment techniques for steel in reinforced concrete exposed to brine water environments

Abstract

Abstract Corrosion assessment of steel-reinforced concrete specimens submerged in synthetic brine water with various chloride concentrations for 1–16 weeks was performed. Mass loss measurements combined with electrochemical techniques – half-cell potential, linear polarization (LP), and electrochemical impedance spectroscopy (EIS) – were employed. The results obtained from all corrosion assessments – on-site testing (half-cell potential measurements), laboratory scale (LP and EIS measurements), and destructive testing (mass loss or immersion measurements) – exhibited remarkable consistency, complementarity, and mutual supportiveness. Corrosion rate (CR) values from mass loss were close to those obtained from LP and EIS. The corrosion resistance decreased with increasing chloride concentration and immersion time, as indicated by the highest CR, Ca2+, and Fe2+ concentrations, and the lowest half-cell potential and polarization resistance. X-ray photoelectron spectroscopy investigation on the corroded steel surface revealed Fe(III) oxides and hydroxides and Fe(III) (FeCl3), corresponding to the reduction in polarization resistance in the LP and EIS results.