A Compact C-Band Multiple-Input Multiple-Output Circular Microstrip Patch Antenna Array with Octagonal Slotted Ground Plane and Neutralization Line for Improved Port Isolation in 5G Handheld Devices

Abstract

In this paper, an eight-port antenna array is presented for 5G handheld terminals to support multiple-input multiple-output (MIMO) operations. The reported design involves three layers: the top contains eight circular microstrip feed elements; the middle is a low-cost FR-4 substrate, and the bottom layer is a ground plane with four etched octagonal slots. Each resonating element is fed by 50-ohm sub-miniature connectors. To mitigate the detrimental effects of mutual coupling of ports and enhance overall isolation between the adjacent microstrip-fed circular patch elements, a neutralization line is strategically implemented between the feed lines of the antenna array. The design configuration involves two elements at each vertex of the printed circuit board (PCB). The overall dimensions of the PCB are 150 × 75 mm2. Each slot and its corresponding radiating elements exhibit linear dual polarization and diverse radiation patterns. The proposed antenna design achieves the required operating bandwidth of more than 1000 MHz spanning from 3 to 4.2 GHz, effectively covering all the upper C-band frequency range of 3.3 GHz to 4.2 GHz allocated for 5G n77 and n78 frequency range 1 (FR1). Required port isolation and lower envelop correlation coefficient (ECC) are achieved for the band of interest. The proposed design gives a peak gain of up to 4 dB for the said band. In addition to these results, degradation in the performance of the antenna array is also investigated during different operating modes of the handheld device. Measured results from the fabricated unit cell and whole array also have a good match with simulated results. On the whole, the proposed antenna possesses the potential to be used in 5G and the open radio access network (ORAN) compliant handheld devices.