A bi-layer barrier design for 122-type iron-based superconducting wires and tapes

Abstract

Iron-based superconducting wires and tapes hold great promise for high-field magnet applications. A promising design for 122-type wires and tapes based on the powder-in-tube method is using silver and copper double-layer sheaths. For this design a heat treatment temperature below ∼ 779 °C is required to prevent Ag-Cu liquid formation. However, this may be below the optimal heat treatment temperature for the critical current density, and still cannot prevent Ag-Cu interdiffusion occurring in the solid state. In this work we propose adding a niobium or tantalum or vanadium (or their alloys) barrier layer between the Ag and Cu to solve the Ag-Cu interdiffusion issue, given that the group-VB metals (vanadium, niobium, tantalum) are relatively inert to both Ag and Cu. To investigate the effectiveness of this design, BaFe1.84Co0.16As2 wires and tapes with Ag/Cu and Ag/Ta/Cu sheaths, as well as Ba0.6K0.4Fe2As2 wires and tapes with Ag/Cu and Ag/Nb/Cu sheaths, were fabricated. It was found that both the Ta and Nb layers kept integral after wire drawing, but after a large flat-rolling reduction the Ta layer broke while the Nb layer kept integral. In the tapes with Ag/Cu sheaths (without the Ta or Nb layer) Cu diffused through the Ag layer and into the powder cores during 740 °C heat treatment, while in the tapes with Ag/Nb/Cu sheaths the Nb layer effectively blocked Ag-Cu interdiffusion even at 900 °C. This work demonstrates that Ta is a suitable barrier material for 122-type wires, while Nb is suitable for both wires and tapes. In this design using Ag/Nb (or Ta)/Cu sheaths, we can regard the outer Cu as the conductor matrix while the Ag and Nb (or Ta) serve as two layers of barriers that suppress reactions between the components. Thus, we call this design a “bi-layer barrier” design for 122-type wires and tapes.