A 90-GHz Asymmetrical Single-Pole Double-Throw Switch With >19.5-dBm 1-dB Compression Point in Transmission Mode Using 55-nm Bulk CMOS Technology

Abstract

The millimeter-wave (mm-wave) single-pole double-throw (SPDT) switch designed in bulk CMOS technology has limited power-handling capability in terms of 1-dB compression point (P1dB) inherently. This is mainly due to the low threshold voltage of the switching transistors used for shunt-connected configuration. To solve this issue, an innovative approach is presented in this work, which utilizes a unique passive ring structure. It allows a relatively strong RF signal passing through the TX branch, while the switching transistors are turned on. Thus, the fundamental limitation for P1dB due to reduced threshold voltage is overcome. To prove the presented approach is feasible in practice, a 90-GHz asymmetrical SPDT switch is designed in a standard 55-nm bulk CMOS technology. The design has achieved an insertion loss of 3.2 dB and 3.6 dB in TX and RX mode, respectively. Moreover, more than 20 dB isolation is obtained in both modes. Because of using the proposed passive ring structure, a remarkable P1dB is achieved. No gain compression is observed at all, while a 19.5 dBm input power is injected into the TX branch of the designed SPDT switch. The die area of this design is only 0.26 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> .