Abstract
Recent high-speed digital-to-analogue converters (DACs) cannot be easily characterised at their highest rate because of the very high cost of commercially available bit-error rate testers at the required DACs rate. Among possible solutions, an inexpensive approach is the use of a multiplexer (MUX) with built-in memory to provide the required bit stream for one input bit of the DAC. This work presents a half-rate 32 GSps MUX with 1 kbit built-in memory as a part of an arbitrary test signal generator for a DAC. The proposed system can be used to test DACs developed for future OFDM optical communications. Here, a bipolar-CMOS (BiCMOS) 0.25 μm SiGe process is utilised. One challenge is to optimise the power dissipation of such an MUX which requires employing several techniques. At the system level, the conventional tree structure was avoided because of the high number of latches required to re-time the clock and data signals. At the highest rates, a multiphase-clock architecture was utilised which halves the number of latches compared with a tree structure. The phase margin of the multiphase-clock structure is enhanced in this work. At lower rates, a one-stage MUX architecture was used which also halves the number of latches. Additionally, the latency between the analogue–digital interface is discussed. All the implemented circuits including the biasing of the whole chip and its routing are presented. The design and optimisation of the clock driver for low-power functionality is discussed. Measurement results show proper operation at 32 GSps. The total power dissipation is 875 mW, which is the lowest power among the designs usable for DAC testing and at the same rate class.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have