Abstract
This paper presents a low-power low-noise instrumentation amplifier (IA) intended for biopotential signal recordings. The IA is designed based on a capacitively-coupled topology, which achieves wide input common-mode range, high common-mode rejection ratio (CMRR) and low power consumption. To reduce low-frequency noise and output ripple at the same time, a combination of chopping and ping-pong auto-zeroing techniques, which is normally used in current-feedback IAs, is introduced for the capacitively-coupled topology in this paper. An intrinsic adverse effect of the proposed structure which causes additional ripple is analyzed. The DC electrode offset voltage is suppressed and the input impedance is boosted through feedback techniques. An improved switched-capacitor common mode feedback (SC CMFB) circuit is also presented. Test results show that the IA achieves an equivalent input-referred noise power spectrum density of 60 nV/sqrtHz and a noise efficiency factor (NEF) of 5.58. The bandwidth is 0.5 Hz to 10 kHz, covering most biopotential recording applications. The IA was implemented in 0.18-μm CMOS process. It occupies 0.27 mm2 core area and consumes 3.6 μA from a 1 V supply.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
