Abstract
This work presents a low-noise variable gain amplifier (LNVGA) in which the IIP2 is very high, and the gain control is applied to improve the system dynamic range, even with the limitations of the CMOS technology. Two stages compose the LNVGA, a low-noise amplifier, that keeps the noise figure (NF) at low values, and a variable voltage attenuator (VVA), that provides the gain variation. We have applied on the VVA the phase cancellation technique, in which the addition of two out-of-phase signals controls the gain. This technique provides a large gain tuning range only if the paths of the two signalsto be added are well balanced; hence, a precise 180 degrees phase difference is required. In this desing we propose an active balun with small imbalance, which creates those signals. The LNVGA was implemented in 130 nm CMOS with a 1.2 V supply. The measurement results show a 35 dB gain tuning range, varying from 10 to − 25 dB, a 4.9 dB minimum NF, a − 10 dBm IIP3, and an IIP2 as high as + 40 dBm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.