Abstract
This paper presents a fully-integrated CMOS temperature sensor for densely-distributed thermal monitoring in systems on chip supporting dynamic voltage and frequency scaling. The sensor front-end exploits a sub-threshold PMOS-based circuit to convert the local temperature into two biasing currents. These are then used to define two oscillation frequencies, whose ratio is proportional to absolute-temperature. Finally, the sensor back-end translates such frequency ratio into the digital temperature code. Thanks to its low-complexity architecture, the proposed design achieves a very compact footprint along with low-power consumption and high accuracy in a wide temperature range. Moreover, thanks to a simple embedded line regulation mechanism, our sensor supports voltage-scalability. The design was prototyped in a 180nm CMOS technology with a 0{\deg}C $-$ 100{\deg}C temperature detection range, a very wide supply voltage operating range from 0.6V up to 1.8V and very small silicon area occupation of just 0.021$mm^2$. Experimental measurements performed on 20 test chips have shown very competitive figures of merit, including a resolution of 0.24{\deg}C, an inaccuracy of $\pm$1.4{\deg}C, a sampling rate of about 1.5kHz and an energy per conversion of 1.06nJ at 30{\deg}C.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.