Abstract
The optimal tensile bond strength of zirconia reinforced lithium-disilicate after multiple glazing firing protocols, different etching time and etchant concentration needs to be evaluated. Purpose of this study was to evaluate the effect of different firing cycles and etching condition on resin cement tensile bond strength of zirconia reinforced lithium disilicate system glass ceramics to titanium. Square-shaped specimens (N=53) were prepared from blocks of zirconia reinforced lithium silicate glass ceramics (CeltraDUO) with 12.5 mm×14 mm rectangular tiles of 2 mm thickness. The specimens were subjected to different firing cycles and etching conditions. They were cemented onto titanium rods (Grade V Ti-alloy, 4.8 mm in diameter, and 1 inch in length) with a resin cement (Theracem), and then tested for tensile bond strength. Least square mean linear regression model was used to analyze the effects on tensile bond strength data using JMP Pro 13.2, followed by the post hoc Tukey tests and tests (α= 0.05). The tensile bond strength was significantly affected by etching duration (p<0.001) and firing cycles (p<0.001), but not significantly affected by etchant concentration (p=0.31). The highest load to failure was observed at 30-60 seconds of etching time and the least load to failure was observed at 20 seconds of etching time. In terms of firing cycles, 1 firing cycle provided the highest load to failure in contrast to least load to failure observed with no firing. Changes in etching time and firing condition of the specimens had a significant effect on the resin cement tensile bond strength of zirconia reinforced lithium disilicate. On the other hand etching the specimens under different concentrations of 5 and 9.6% did not differ statistically in terms of resin cement tensile bond strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.