Similar Papers

Paper Title
Journal
Date
Author
Unambiguous Tracking Method for Alternative Binary Offset Carrier Modulated Signals Based on Pseudo Correlation Function Technique
Yanling Zhou ... Yongcai Pan
IEEE Communications Letters | VOL. 19
Yanling Zhou, et. al.Yanling Zhou ... Yongcai Pan
01 Mar 2015
A critical investigation of the phase shift between the inner and outer modulation for the control of machine tool Chatter
Y.S Tarng ... E.C Lee
International Journal of Machine Tools and Manufacture | VOL. 37
Y.S Tarng, et. al.Y.S Tarng ... E.C Lee
01 Dec 1997
A new on-line spindle speed regulation strategy for chatter control
Y.S Liao ... Y.C Young
International Journal of Machine Tools and Manufacture | VOL. 36
Y.S Liao, et. al.Y.S Liao ... Y.C Young
01 May 1996
Predicting tool flank wear using spindle speed change
J.E Kaye ... S Balakrishnan
International Journal of Machine Tools and Manufacture | VOL. 35
J.E Kaye, et. al.J.E Kaye ... S Balakrishnan
01 Sep 1995
View more papers

More From: Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21

Paper Title
Journal
Date
Author
Development of ice 3D printer applying supercooling phenomenon
Anno Tanaka ... Ryo Koike
Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21 | VOL. 2021.10
Anno Tanaka, et. al.Anno Tanaka ... Ryo Koike
01 Jan 2020
Consideration of Biaxial Flexible Support Table for Fine Positioning Through Controlled Magnetic Attraction Forces
Yuma Tamaru ... Hiroki Shimizu
Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21 | VOL. 2021.10
Yuma Tamaru, et. al.Yuma Tamaru ... Hiroki Shimizu
01 Jan 2020
Influence of Hot Shot Peening on Surface Reforming and Local Alloying
Akihiro Takemura ... Yasuhiro Tanaka
Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21 | VOL. 2021.10
Akihiro Takemura, et. al.Akihiro Takemura ... Yasuhiro Tanaka
01 Jan 2020
Observation of gap phenomenon in electrochemical machining by using electrolyte suction tool with auxiliary anode
Teppei Takata ... Wataru Natsu
Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21 | VOL. 2021.10
Teppei Takata, et. al.Teppei Takata ... Wataru Natsu
01 Jan 2020
View more papers

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.