3-D imaging of the Balmuccia peridotite body (Ivrea–Verbano zone, NW-Italy) using controlled source seismic data

Abstract

SUMMARY We provide new results from a controlled-source seismic experiment on the deepest part of the Val Sesia crust–mantle section of the Ivrea–Verbano zone (IVZ) in the Italian Alps. The IVZ is a tilted, almost complete section through the continental crust and exposes gabbros and peridotites in the structurally deepest level, coinciding with high-resolution gravity anomalies imaging the Ivrea geophysical body. The seismic experiment SEIZE (SEismic imaging of the Ivrea ZonE) was conducted along two crossing profiles: an NNE-SSW profile of ∼11 km length and an E-W profile of ∼16 km length. 432 vibration points were recorded with 110 receivers resulting in 24 392 traveltime picks. Inversion methods using Markov chain Monte Carlo techniques have been used to derive an isotropic 3-D P-wave velocity model based on first break traveltimes (refracted phases) from controlled source seismic data. Resulting seismic P-wave velocities (Vp ) range from 4.5 to 7.5 km s−1, with an expected general trend of increasing velocities with depth. A sharp velocity change from low Vp in the West to high Vp in the East marks the Insubric Zone (ISZ), the Europe–Adria plate boundary. The most prominent feature of the 3-D tomography model is a high-velocity body (Vp increases from 6 to 7.5 km s−1) that broadens downwards. Its pointy shape peaks the surface East of Balmuccia at a location coincident with the exposed Balmuccia peridotite. Considering rock physics, high-resolution gravity and other geophysical data, we interpret this high-velocity body as dominantly composed of peridotite. The dimension of this seismically imaged peridotite material is far bigger than interpreted from geological cross-sections and requires a revision of previous models. The interpretation of ultramafic bodies in the IVZ as fragments of mantle peridotites interfingered in the crust during pre-Permian accretion is not supported by the new data. Instead, we revive a model that the contact between the Balmuccia peridotite and the Permian mafic magmas might represent a fossil continental crust–mantle transition zone.