Abstract
This study describes changes of surface roughness of semifusinite and fusinite as an indicator of structural alteration resulting from heat treatment at 400–1200 °C. Surface roughness has been investigated by atomic force microscopy of inertinite concentrates from coking coals (vitrinite reflectance Rr = 1.07%–1.41%) from the Upper Silesian Coal Basin of Poland (Namurian C — Westphalian A). Unheated fusinite has a higher surface roughness than semifusinite from the same coal. The average surface roughness of semifusinite decreases with the Swelling Index of the parent coal. Heating increases the surface roughness of semifusinite and fusinite. Increase in the average surface roughness is stronger for semifusinite than fusinite and correlates to increasing reflectance of these macerals. The surface roughness of semifusinite correlates to the relative mass loss of the inertinite concentrates during heating. After heating to 1200 °C fusinite has a lower average surface roughness than semifusinite from the same coal. Consequently, average surface roughness can be used as a measure of structural alteration of inertinite group macerals during heat treatment.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
