Abstract
In the paper there is under consideration an effort to achieve the roughness index of Ra <0.8 with the aid of soft abrasive tool use. As a result the purpose of this work became development of the technology for surface quality improvement of parts manufactured with the aid of additive technologies. 
 The authors carried out a number of experiments with the samples manufactured with the aid of the method of FDM print. With the aid of 3D Ultra 3 printer of EnvisionTec company. The samples were made of ABS-plastic in the amount of 6 pieces. On each sample there were defects after printing which contributed to the deterioration of surface quality in products. By means of TR220 profilometer there was measured roughness before and after the experiment. There was carried out dry processing and with the use of SCL. As a result, dry processing resulted in worsening surface quality, heavy wear of an abrasive tool and grain contamination. Analyzing the data obtained from the profilometer in the experiment and SCL use a considerable improvement of the surface layer quality at minimum allowance is observed. 
 Investigation methods: in the work basis there are experimental methods of investigation. The investigations are carried out with the use of a microscope and profilometer. Processing investigation results was carried out as a result of the comparison of the measuring data obtained. 
 Work Novelty: there are defined conditions of soft abrasive tool operation and SCL impact upon Ra indices. 
 The results obtained indicate a possibility of Ra improvement on a part surface which is achieved due to a combined shaping with the aid of additive technologies and further machining carried out on a single technological basis. The experience without SCL use has shown the overheating possibility the result of which is a meltback and plastic sticking both on the surface, and on abrasive grains of the cutter which is inadmissible and results in considerable worsening of Ra on the surface machined and cutter wear. 
 In view of this the SCL use in finishing is promising, but to achieve better results SCL chemistry must be improved.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
