Abstract
The article proposes the further development of a method of reducing the error of measuring local changes in the electrical conductivity of electrolyte solutions caused by a change in the background electrical conductivity of the measuring medium. Such an error occurs in differential conductometric biosensors with working and reference transducers, if their electrical parameters differ significantly. In contrast to the previously known, the described method takes into account the influence of near-electrode charge transfer resistances, which becomes especially noticeable when there is a significant difference in the values of these parameters of the converters. The goal is to ensure deep suppression of the influence of background changes in electrical conductivity of solutions under significant differences in the reactive and active component impedances of pairs of sensor transducers, including near-electrode charge transfer resistances. Mathematical expressions characterizing the process of bringing the bridge measuring circuit to a specific state of quasi-balance, in which the influence of changes in the background electrical conductivity of electrolyte solutions is minimal, are considered. Formulas for calculating the voltage parameters on the reference converter have been obtained, which make it possible to establish the indicated mode of the measuring circuit. A technique for determining the values of charge transfer resistances using the results of additional measurements of the impedance parameters of the converters at a frequency higher than the operating frequency is proposed. The results of research on suppressing the effect of changes in the background electrical conductivity of the solution in the differential conductometric channel using a computer model are presented, which showed the possibility of significantly reducing the effect of changes in the background electrical conductivity of the solution compared to the known method. References 9, figures 2, table 1.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.