Abstract
Influence on honing performance is investigated about grain's toughness and operating conditions such as honing speed, crosshatch angle and honing fluid. Workpieces are three types of ceramics sintered under atmospheric pressure, that is, silicon nitride Si3N4, silicon carbide SiC and alumina Al2O3. Moreover, some discussions are had to confirm how effective the honing operation is for machining of ceramics. The results are as follows. Influence of grain's toughness on its cutting ability is a little for Al2O3 with good machinability. But, for SiC and Si3N4 with poor machinability, diamond grains having high toughness should be used. In order to restrain the wear of cutting grains, the honing speed and the stone pressure should be decreased. The large crosshatch angle makes it possible to obtain high productivity, because the cutting edges collide against cutting tracks with a large angle. The characteristic and the temperature of the honing fluid are important factors to use diamond sticks effectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of the Japan Society of Precision Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.