Abstract
We have developed a digital control rod control system not only to improve its performance but also to improve its reliability and speed of response so that it can replace the old fashioned analog system. However, a new developed digital control system should be tested to prove the validity by using any prototype or mock-up before application. The reliability prediction and the reliability block diagram analysis methods were adopted to verify the reliability of the developed hardware. For the case of software, especially for a new developed control algorithm, it has been tested to prove performances and validation by using a dynamic simulator and mock-up of control rod drive mechanism altogether. Here we want to present some key factors regarding to the new developed digital system with some verification procedures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transactions of the Korean Society of Mechanical Engineers A
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
