Abstract
During the development of various designs of products, it is sometimes difficult to conduct preliminary tests of their full-scale models. This is influenced by many factors, including the dimensions of the product, the cost of manufacturing, the complexity of developing specialized laboratory installations, etc. Therefore, product models are used for testing, which are several times smaller than the actual size. One of such products, which is rather difficult to produce in life size and to conduct its research, is the seal of the universal preventer (bag type preventor). However, a reduced model was created to study its characteristics. For this, a popular today's method of manufacturing products was used - 3D printing, with the help of which both the gasket inserts and the mold for its casting were made. Silicone SKR-788 is used as a material for pouring the sealant. In the following studies of the design of the seal of the bag type preventor, it is planned to carry out a series of simulations of the fragments of the seal with different geometric shapes and sizes of inserts in order to determine their optimal options. To confirm the obtained results of simulation modeling, laboratory tests will be conducted on the installation for researching the design of universal preventer seals.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International scientific and technical conference Information technologies in metallurgy and machine building
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
