Информационные свойства частотных характеристик динамической системы резания при диагностике износа инструментов

Abstract

Introduction. One of the directions for increasing the efficiency of cutting is related to the creation of tool wear diagnostic systems. Algorithms and devices have been developed that evaluate wear based on analysis of the vibroacoustic emission signal. These algorithms, as a rule, do not reveal the nature of its formation and the reasons for the change as wear develops. Subject. The paper is devoted to the analysis of the reasons for changes in vibration properties with the development of tool wear. The aim of the work is to study the changes in the frequency characteristics of a dynamic cutting system caused by the development of wear, and to build diagnostic information models on this basis, as well as its use in industry. Method and methodology. The results of mathematical simulation of a perturbed dynamic cutting system are presented, in which the observed vibration sequences are a consequence of disturbances transformed by a dynamic system, the parameters of which depend on wear. Two frequency ranges are considered. Results and discussions. The first range includes frequencies that lie within the bandwidth of the instrument subsystem. The second is outside of it. In the first frequency range, it has been analytically and experimentally proven that the development of wear leads to fundamental changes in the frequency properties of the cutting system as a converter of disturbances into tool vibrations. There is a shift in the natural frequencies of the oscillatory circuits formed by the cutting system, a decrease in its quality factor, and as wear develops, some identified features of the vibration spectra appear, including the ratio of the low-frequency and high-frequency parts of the spectrum, etc. In the second frequency range, a model of force emission in the form of a random pulse sequence is considered and wear is displayed in it. The results of studying the coherence function between the forces acting on the tool and vibrational displacement are presented. Information models of wear are proposed, an example of an information model of wear and the results of its use in industry are given.