Abstract
The article considers the possibility of using vibration treatment of blind holes in products obtained by the SLS method. The experimental results showed that the most effective treatment occurs when the hole diameter exceeds the size of the abrasive body by 1-2 mm, but does not exceed it by 2 times. It was also noted that the rounding of the edge of the hole with a size not exceeding the nominal value of the abrasive occurs faster than that of a hole with a larger size. The time of rough processing of stainless steel products should not exceed 4 hours, while the most effective processing occurs in the first 2-3 hours. The results obtained allow us to give recommendations on the processing of printed products with blind holes made by the SLS method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
