Abstract
The problems of cutting tools supply interaction from abroad due to sanctions rollout and new possibility of full-fledged replacement of these tools with the relevant cutting tools of domestic production are viewed. The results of linking comparative research of cutting geometry impact on physical parameters, comparing lamellar tooth material and coatings in lathe knives of various foreign firms and similar domestic lamellar teeth of the Kirovograd carbide materials plant using the modes of finish-turning, semi-rough and rough turning operations by means of the computer-aided diagnostics center, are presented. It is found that in most parameters, cutting tools of domestic manufacture is absolutely equal to the best foreign tools and can be recommended substitution-ally for various machine-building enterprises in Russia.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Science intensive technologies in mechanical engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
