Исследование распада пересыщенного твердого раствора в высокомагниевых алюминиевых сплавах со скандием, легированных гафнием

Abstract

Magnesium-rich aluminum alloys with small scandium additives are widely used in many branches of modern industry due to the high level of their mechanical properties. However, the issue of low thermal stability of Al3Sc particles, which does not allow performing deformation processing of this group of alloys at a temperature above 400 °С, continues to be relevant. Hafnium addition can become one of the ways to solve this problem as hafnium forms a shell around the Al3Sc particles and, due to the low diffusion coefficient in the aluminum matrix, reduces their coagulation rate. The paper studies the influence of addition of 0.2 % and 0.5 % Hf on the electrical conductivity and the process of supersaturated solid solution decomposition, as well as on the size and quantity of nanoparticles in the 1570 magnesium-rich aluminum alloy at its thermal treatment. The authors studied the kinetics of supersaturated solid solution decomposition in the 1570, 1570–0.2Hf, and 1570–0.5Hf alloys by the electrical conductivity measuring and constructed C-curves describing the supersaturated solid solution decomposition in the studied alloys in the temperature range of 260–440 °С. Besides, using transmission electron microscopy, the strengthening nanoparticles of the 1570 and 1570–0.5Hf alloys were studied during heating to 370 °C and 4-hour soaking. The study showed that hafnium addition significantly slows down the supersaturated solid solution decomposition in the 1570 alloy. The authors identified that in the alloys with hafnium additives, the supersaturated solid solution decomposition is the most intense at a temperature of 350 °С, and in the alloys without hafnium – at a temperature of 430 °С. The transmission microscopy data confirm that the 1570 alloy without hafnium contains 3–4.5 times more nanoparticles than the 1570–0.5Hf alloy.