Предложения в методику испытаний технических средств защиты стальных сварных бытовых баллонов для СУГ от физического разрушения при воздействии пожара

Abstract

Разработана методика проведения испытаний технических средств защиты стальных сварных бытовых баллонов для сжиженных углеводородных газов (СУГ) от физического разрушения при воздействии на них пожара. В методике содержатся требования к отбору газовых баллонов, рассматриваемым модельным сценариям, установке для испытаний, мероприятиям по подготовке испытаний, порядку их проведения, к отчету о проведении испытаний. Использование предлагаемой методики позволит с высокой степенью достоверности оценивать эффективность применения технических средств защиты стальных бытовых баллонов для СУГ от физического разрушения при воздействии пожара. The paper contains proposals for inclusion in the testing methodology for technical means of protecting gas cylinders from physical destruction. The proposals relate to the choice of typical scenarios characteristic for emergencies and fire development in a room with LPG cylinders: the ingress of cylinders into the fire center, the impact on the cylinder surface of the heat flow of the adjacent fire center; the impact on the surface of the cylinder of LPG vapors jet combustion, simulating the effect of combustion of LPG vapors coming out of the outlet of the valve (safety valve or membrane) of the adjacent cylinder. The design of the installation for testing cylinders in accordance with the above scenarios is presented. There are given requirements for the test preparation procedure, including the verification of documentation, installation of technical protective equipment, filling and delivery of cylinders, checking for gas leaks from cylinders after delivery, installation for testing. A detailed description of the installation procedure is given in accordance with the presented diagrams for various test scenarios. The basic diagrams of the measuring system for the pressure inside the cylinder, mounting of thermocouples on the wall of the cylinder, and remote supply of liquid fuel to trays are described. There is described the test procedure, which consists of turning on the recording systems, gas supplying to the installation, activating the cylinder heating system, video recording of the experiment with timing, closing the valve in front of the pressure sensor after the end of combustion, discharging LPG from the sealed cylinder to the burner. The requirements for the composition of the test report are given, which make it possible to confirm the reliability of the experiments.