Wave External-cavity Quantum Cascade Research Articles

High power, widely tunable, mode-hop free, continuous wave external cavity quantum cascade laser for multi-species trace gas detection

We present a high power, widely tunable, continuous wave external cavity quantum cascade laser designed for infrared vibrational spectroscopy of molecules exhibiting broadband and single line absorption features. The laser source exhibits single mode operation with a tunability up to 303 cm−1 (∼24% of the center wavelength) at 8 μm, with a maximum optical output power of 200 mW. In combination with off-axis integrated output spectroscopy, trace-gas detection of broadband absorption gases such as acetone was performed and a noise equivalent absorption sensitivity of 3.7 × 10−8 cm−1 Hz−1/2 was obtained.

On the application of cw external cavity quantum cascade infrared lasers for plasma diagnostics

Three continuous wave external cavity quantum cascade lasers (EC-QCLs) operating between 1305 and 2260 cm−1 (4.42–7.66 µm) have been tested as radiation sources for an absorption spectrometer focused on the analysis of physical and chemical phenomena in molecular plasmas. Based on the wide spectral tunability of EC-QCLs, multiple species detection has become feasible and is demonstrated in a study of low-pressure Ar/N2 microwave plasmas containing methane as a hydrocarbon precursor. Using the direct absorption technique, the evolution of the concentrations of CH4, C2H2, HCN and H2O has been monitored depending on the discharge conditions at a pressure of p = 0.5 mbar and at a frequency of f = 2.45 GHz in a planar microwave plasma reactor. The concentrations were found to be in the range of 1011–1014 molecules cm−3. In addition, based on the analysis of the line profile of selected absorption lines, the gas temperature Tg has been calculated in dependence on the discharge power. Tg increased with the power values and was in the range between 400 and 700 K. Further, in a pure He/Ar microwave plasma, the wavelength modulation spectroscopy technique has been applied for the sensitive detection of transient plasma species with absorbencies down to 10−5. The typical spectral line width of an EC-QCL under the study was found to be in the range 24 to 38 MHz depending (i) on the chopping technique used and (ii) on a single or averaged measurement approach. Further, different methods for the modulation and tuning of the laser radiation have been tested. Varying the power values of an EC-QCL between 0.1 and 154 mW for direct absorption measurements under low pressure conditions, no saturation effects in determining the concentrations of methane, acetylene and carbon monoxide could be found under the experimental conditions used, i.e. for lines with line strengths between 10−19 and 10−22 cm molecule−1.

Dual beam photoacoustic infrared spectroscopy of solids using an external cavity quantum cascade laser

Quantum cascade laser-based instrumentation for dual beam photoacoustic (PA) spectroscopy is described in this article. Experimental equipment includes a 4.55 μm (2141-2265 cm(-1)) continuous wave external cavity quantum cascade laser (EC-QCL), two gas-microphone PA cells, and two lock-in amplifiers. Correction for the time and wavenumber dependence of the laser output is effected through real-time division of the PA signals derived from the sample and reference channels. Source-compensated mid-infrared absorption spectra of carbon black powder and aromatic hydrocarbon solids were obtained to confirm the reliability of the method. Absorption maxima in the EC-QCL PA spectra of hydrocarbons are better defined than those in Fourier transform infrared spectra acquired under similar conditions, enabling the detection of several previously unknown bands.

Applications of midinfrared quantum cascade lasers to spectroscopy

We review the use of both pulsed and continuous wave quantum cascade lasers in high-resolution spectroscopic studies of gas phase species. In particular, the application of pulsed systems for probing kinetic processes and the inherent rapid passage structure that accompanies observations of low-pressure samples using these rapidly chirped devices are highlighted. Broadband absorber spectroscopy and time-resolved concentration measurements of short-lived species, respectively exploiting the wide intrapulse tuning range and the pulse temporal resolution, are also mentioned. For comparison, we also present recent sub-Doppler Lamb-dip measurements on a low-pressure sample of NO, using a continuous wave external cavity quantum cascade laser system. Using this methodology the stability and resolution of this source is quantified. We find that the laser linewidth as measured via the Lamb-dip is ca. 2.7 MHz as the laser is tuned at comparably slow rates, but decreases to 1.3 MHz as the laser scan rate is increased such that the transition is observed at 30 kHz. Using this source, wavelength modulation spectroscopy of NO is presented.

Direct and wavelength modulation spectroscopy using a cw external cavity quantum cascade laser

A continuous wave external cavity quantum cascade laser (EC-QCL) operating between 1872 and 1958 cm−1 has been used to make rotationally resolved measurements in the fundamental band of nitric oxide at 140 mTorr, and the ν2 band of water at atmospheric pressure. These measurements demonstrate the advantages of wide tunability and high resolution of the EC-QCL system. From direct absorption spectroscopy on nitric oxide a laser bandwidth of 20 MHz has been deduced and a sensitivity of 8.4×10−4 cm−1 Hz−1/2 was achieved. Wavelength modulation spectroscopy using current modulation enhances the sensitivity by a factor of 23 to 3.7×10−5 cm−1 Hz−1/2.