When surface-active molecules or particles assemble at fluid–fluid interfaces, these interfaces acquire complex rheological properties that are of importance in processes that involve flow and deformation of interfaces. Although much progress has been made, interfacial rheology measurements and, in particular, the measurement of interfacial rheological properties of polymers at the air-water interface remain challenging. These are due to weak interactions with the water subphase, the polymer backbone conformation, the glass transition of the interfacial layer, and memory effects. In the present work, we describe systematic rheological measurements of polymer-laden interfaces. The measurements were performed with four different interfacial shear rheometers that can be classified into two types: rheometers in which the surface pressure can be controlled independently, and devices based on fixtures mounted on standard rotational rheometers and lacking control of the surface pressure. We use poly(tert-butyl methacrylate) and poly(methyl methacrylate), two high glass transition temperature, hydrophobic polymers anchored to the water subphase by means of the acrylate group. Using a Langmuir–Pockels (LP) trough, we identify the transition of the polymer monolayer from a viscous to a solid elastic or soft-glassy interface as the polymer surface concentration increases by compression. Then, we compare the linear viscoelastic properties of the interface as obtained by each rheometer. Our results show poor reproducibility and comparability of the rheological data as obtained by different rheometers for the same polymer. This is mainly due to differences in the method used to prepare the layers. For LP-based devices, spreading under dilute conditions and subsequent compression yields layers of compressed glassy blobs with reproducible results. On the other hand, for devices without surface pressure control, deposition of the amount needed to reach a desired concentration may lead to the formation of ill-defined layers resulting in irreproducible data. Furthermore, we find that only when spreading the polymer to form a dilute layer and then controlling the surface pressure by compression, we can clearly distinguish the fluidlike from solidlike interfaces, and a clear correlation is observed between the surface pressure (or interfacial polymer concentration) and the rheological properties of the interface.
Read full abstract