The effects of vertical load on the lateral resistance of single piles were initially reviewed to facilitate the interpretation of the test results of pile groups. Then, 18 different lateral load tests were carried out in the centrifuge on the 3 × 3 and the 4 × 4 fixed-head battered pile groups to investigate the effects of vertical load on the group lateral resistance. Vertical dead loads ranging from approximately 20 to 80% of the vertical ultimate group capacity Puv were applied. Based on these tests, the effects of vertical dead load on the lateral resistance of the battered pile groups are found to depend on pile arrangement, pile inclination, and soil density. The lateral resistances of the 3 × 3 pile groups do not appear to vary considerably with the vertical dead loads in the range of the vertical loads studied. For the 4 × 4 pile groups however, the lateral resistances at vertical loads of approximately 50 and 80% Puv may be 26-29% and even 40% higher than that at the 20% Puv dead load. It may be inferred that designs based on standard lateral load tests with small vertical dead loads would be on the safe side. Three mechanisms for vertical load effects are discussed in terms of axial tension and compression failures, influence of pile inclination, and initial subgrade reaction caused by vertical loading. Preliminary numerical analyses are also performed to simulate the responses of some of the battered pile groups.Key words: pile group, battered pile, lateral resistance, load test, pile-soil interaction, centrifuge test.