Several industries are interested in Laser Powder Bed Fusion (L-PBF) Additively Manufactured (AM) metal parts because their designs can be made arbitrarily complex while retaining bulk-type material properties. However, the residual stresses (RS) and distortions caused by the heat gradients inherent to L-PBF processes are detrimental to the structural integrity of the parts and must be taken into consideration during the part design cycle. Predicting the state of stresses in as-built 3D printed parts is a difficult problem that is typically approached with the use of transient thermomechanical Finite Element Models (FEMs). However, the nonlinearities associated with AM processes are difficult to capture in these FEMs without increasing the computational cost of the simulation, limiting their ability to be incorporated into practical design cycles. This work presents a novel analytical framework that combines lumped capacitance nonlinear heat transfer with time dependent classical lamination theory to efficiently and accurately predict RS in as-built L-PBF parts without the need of FEMs. The simulation was compared to Neutron Diffraction (ND) residual strain measurements taken at Oak Ridge National Laboratories (ORNL) as well as Synchrotron X-ray Diffraction (XRD) strain data published by the National Institute of Standards and Technology (NIST). The simulation predictions and the experimental data showed excellent agreement for the in-plane strain directions, and general agreement for the out of plane strain component, highlighting an area where further development can be implemented.
Read full abstract