Due to the weak feed characteristic of active distribution networks, the sensitivity of the original fault phase selection method and the accuracy of fault location are decreased. Most of the existing fault section location methods focus on the phase selection and location of the earth fault, and there is a lack of relevant research on the location of the fault section to the phase-to-phase fault. Moreover, most of the methods need to install the signal measuring device in the system as large as possible, which is not economical. The operation condition of active distribution networks is complicated, the fault characteristics are weak, and the location result is easily affected by non-fault disturbances such as DG access capacity and location. In this paper, the phase-to-phase fault of active distribution networks is taken as the research object. Firstly, phase current and zero-sequence current combined criterion is used for fault phase selection, and then combined with the phase-frequency characteristics of mode impedance of distribution line and photovoltaic power line, a fault section location method based on transient characteristic frequency band is proposed, which is not affected by non-fault disturbance such as photovoltaic control strategy and DG access capacity and location. Simulation results show that the method is effective.
Read full abstract