Times Higher Amplitude Research Articles

Vibrational Analysis on Cooling Fan with Induced Mechanical Faults

Abstract This paper reports the investigation of different mechanical faults such as unbalanced loading, broken blades, and deformed blades induced in a fan using vibration analysis. The fan used in this study was a CPU cooling fan as a representation of a basic fan system giving an idea of vibration signatures when it is subjected to faults conditions. This study assists in developing the techniques of condition monitoring for the diagnosis of failures and faults in fan systems while logging the operating status and trend in performance. The investigation is carried out in the turbine testing lab using a Tri-axial accelerometer and a commercial Intel® CPU cooling fan consisting of 7 blades. The fan was run at different RPMs with normal and fault conditions like unbalanced loading conditions induced by adding mass of different weights, breakage of blades, deformation of blades, and holes in the blades. These faults are induced to simulate various mechanical faults that frequently occur in fan-based systems. The vibration data obtained from the accelerometer are filtered and the time series of acceleration values are plotted using MATLAB. For further analysis of data, the Fast Fourier Transform is done to evaluate the peaks of vibration signals in normal and fault conditions. Vibrational amplitude in fault conditions like Hole-2 has 4.5 times higher amplitude than normal and Cut-2 has 31.5 times higher amplitude.

Linking laser-induced and self-induced signals in double trench isolated LGADs: Implications for signal anomalies in interpad region

In this article, we present our research on the space-charge effects in segmented LGADs, specifically the interpad (IP) region, with a focus on double trench isolated LGADs (2Tr TI-LGADs). We found that the examined 2Tr sample showed different induced current signals in the IP region compared to previously studied sensors with different isolation structures. We identified two types of laser pulse induced signals in the IP region: “normal” signal, resembling corresponding pad signals, and “strong” signal represented by significantly broader waveforms with several times higher amplitude. In addition, randomly occurring “ghost” signal appearing in biased but not laser-illuminated sensors were identified during our study. All three types of signals were explored in terms of the influence of bias voltage and laser power at different temperatures. Possible explanations of the observed signals are discussed.

Three‐Dimensional Physical Modeling of Tsunamis Generated by Partially Submerged Landslides

AbstractMassive landslides can generate large tsunamis and endanger human lives and properties. While a number of laboratory experiments on either subaerial or submarine landslide‐tsunamis have been conducted, few studies have focused on partially submerged events. The present study aimed to investigate the characteristics of partially submerged landslide‐tsunamis and to develop a predictive equation that can estimate their heights through three‐dimensional laboratory experiments that used 114 different conditions. The experimental results showed that, while waves generated in the landslide sliding direction had around 1.7 times higher amplitude than those propagating laterally in the near‐field region, the wave period, celerity, and wavelength did not alter significantly according to the propagation angles. The effects of wave dispersion were also shown to be significant during the propagation process. Such wave characteristics were consistent with those reported in existing subaerial landslide tsunami experiments conducted by other researchers. Based on the data set obtained, the authors also derived a predictive equation which was confirmed to be able to estimate the results of other experimental studies on partially submerged landslide‐tsunamis with an error of around ±30%, and thus can be helpful for a rapid tsunami hazard assessment. The developed equation indicated that the volume of a landslide could have more than twice the impact on the height of a partially submerged landslide‐tsunami than other parameters. The effects of the landslide size were also shown to be more significant than in the case of a subaerial landslide‐tsunami, though the wave attenuation process was similar in both types.

Circadian Rhythms in Hormone-sensitive Lipase in Human Adipose Tissue: Relationship to Meal Timing and Fasting Duration.

Fat mobilization in adipose tissue (AT) has a specific timing. However, circadian rhythms in the activity of the major enzyme responsible for fat mobilization, hormone-sensitive lipase (HSL), have not been demonstrated in humans. To analyze in a cross-sectional study whether there is an endogenous circadian rhythm in HSL activity in human AT ex vivo and whether rhythm characteristics are related to food timing or fasting duration. Abdominal AT biopsies were obtained from 18 severely obese participants (age: 46 ± 11 years; body mass index 42 ± 6 kg/m2) who underwent laparoscopic gastric bypass. Twenty-four-hour rhythms of HSL activity and LIPE (HSL transcript in humans) expression in subcutaneous AT were analyzed together with habitual food timing and night fasting duration. HSL activity exhibited a circadian rhythm (P = .023) and reached the maximum value at circadian time 16 (CT) that corresponded to around midnight (relative local clock time. Similarly, LIPE displayed a circadian rhythm with acrophase also at night (P = .0002). Participants with longer night fasting duration >11.20 hours displayed almost double the amplitude (1.91 times) in HSL activity rhythm than those with short duration (P = .013); while habitual early diners (before 21:52 hours) had 1.60 times higher amplitude than late diners (P = .035). Our results demonstrate circadian rhythms in HSL activity and may lead to a better understanding of the intricate relationships between food timing, fasting duration and body fat regulation.

Testing the relativistic Doppler boost hypothesis for the binary candidate quasar PG1302-102 with multiband Swift data

ABSTRACT The bright quasar PG1302-102 has been identified as a candidate supermassive black hole binary from its near-sinusoidal optical variability. While the significance of its optical periodicity has been debated due to the stochastic variability of quasars, its multiwavelength variability in the ultraviolet (UV) and optical bands is consistent with relativistic Doppler boost caused by the orbital motion in a binary. However, this conclusion was based previously on sparse UV data that were not taken simultaneously with the optical data. Here, we report simultaneous follow-up observations of PG1302-102 with the Ultraviolet Optical Telescope on the Neil Gehrels Swift Observatory in six optical + UV bands. The additional nine Swift observations produce light curves roughly consistent with the trend under the Doppler boost hypothesis, which predicts that UV variability should track the optical, but with a ∼2.2 times higher amplitude. We perform a statistical analysis to quantitatively test this hypothesis. We find that the data are consistent with the Doppler boost hypothesis when we compare the the amplitudes in optical B-band and UV light curves. However, the ratio of UV to V-band variability is larger than expected and is consistent with the Doppler model, only if either the UV/optical spectral slopes vary, the stochastic variability makes a large contribution in the UV, or the sparse new optical data underestimate the true optical variability. We have evidence for the latter from comparison with the optical light curve from All-Sky Automated Survey for Supernovae. Additionally, the simultaneous analysis of all four bands strongly disfavours the Doppler boost model whenever Swift V band is involved. Additional, simultaneous optical + UV observations tracing out another cycle of the 5.2-yr proposed periodicity should lead to a definitive conclusion.

Narrow band photoacoustic lamb wave generation for nondestructive testing using candle soot nanoparticle patches

The generation of ultrasonic surface waves with a photoacoustic-laser-source has become useful for the noncontact nondestructive testing and evaluation (NDT&E) of materials and structures. In this work, a hybrid ultrasound based NDT&E method is proposed based on the photoacoustic-laser-source as a noncontact Lamb wave generator by incorporating a line-arrayed patterned candle soot nanoparticle-polydimethylsiloxane (CSNPs-PDMS) patch as the signal amplifier and with a narrow bandwidth. The CSNP-PDMS composite has been investigated as the functional patch for its laser energy absorption efficiency, fast thermal diffusion, and large thermoelastic expansion capabilities. The signal amplitude (in mW) from the CSNP-PDMS patch exhibits 2.3 times higher amplitude than the no patch condition and a narrower bandwidth than other conditions. Furthermore, improvement in the sensitivity is also achieved through the selection of the aluminum nitride sensing system. The overall combination of the Lamb wave generation and receiver-sensing system in this study is found to be very promising for a broad range of noncontact NDT&E applications.

A laser-activated MEMS transducer for efficient generation of narrowband longitudinal ultrasonic waves

In this paper, we demonstrate an optically powered microelectromechanical system (MEMS) transducer. It was designed and fabricated using MEMS techniques, and can generate narrowband ultrasonic bulk waves from a broadband laser excitation pulse with high efficiency. The transducer is a two-mask-level MEMS device with a microdisk seated on a microstem. When a laser pulse is incident on the disk center, a resonant flapping motion of the disk is actuated because of the thermomechanical interaction between the absorbing and non-absorbing parts of the disk, coupling a narrowband longitudinal bulk wave propagating along the axis of the stem into the sample. Finite element (FE) methods were used to simulate the generated ultrasound; the results agree well with experimental measurements. Experiments with the fabricated transducers have shown that narrowband ultrasound with a high SNR/amplitude was generated successfully; compared with normal thermoelastic generation, ultrasound with at least 5 times higher amplitude can be achieved by an optimized MEMS transducer. The transducer is inexpensive, compact, and simple to use.