Thermal Emission Imaging System Data Research Articles

Mineralogical characterization of Mars Science Laboratory candidate landing sites from THEMIS and TES data

Data from the Mars Global Surveyor Thermal Emission Spectrometer (TES) and the Mars Odyssey Thermal Emission Imaging System (THEMIS) instruments are used to assess the mineralogic and dust cover characteristics of landing regions proposed for the Mars Science Laboratory (MSL) mission. Candidate regions examined in this study are Eberswalde crater, Gale crater, Holden crater, Mawrth Vallis, Miyamoto crater, Nili Fossae Trough, and south Meridiani Planum. Compositional units identified in each region from TES and THEMIS data are distinguished by variations in hematite, olivine, pyroxene and high-silica phase abundance, whereas no units are distinguished by elevated phyllosilicate or sulfate abundance. Though phyllosilicate minerals have been identified in all sites using near-infrared observations, these minerals are not unambiguously detected using either TES spectral index or deconvolution analysis methods. For some of the sites, small phyllosilicate outcrop sizes relative to the TES field of view likely hinder phyllosilicate mineral detection. Porous texture and/or small particle size (<∼60 μm) associated with the phyllosilicate-bearing surfaces may also contribute to non-detections in the thermal infrared data sets, in some areas. However, in Mawrth Vallis and Nili Fossae, low phyllosilicate abundance (<10–20 areal %, depending on the phyllosilicate composition) is the most likely explanation for non-detection. TES data over Mawrth Vallis indicate that phyllosilicate-bearing surfaces also contain significant concentrations (>15%, possibly up to ∼40%) of a high-silica phase such as amorphous silica or zeolite. High-silica phase abundance over phyllosilicate-bearing surfaces in Mawrth Vallis is higher than that of surrounding surfaces by 10–15%. With the exception of these high-silica surfaces in Mawrth Vallis, regions examined in this study exhibit similar bulk mineralogical compositions to that of most low-albedo regions on Mars; the MSL scientific payload will thus be able to provide important information on surface materials typical of low-albedo regions in addition to investigating the origin of phyllosilicate and/or sulfate deposits. With the exception of Gale crater, all of the landing sites have relatively low dust cover compared to classic high-albedo regions (Tharsis, Arabia and Elysium) and to previous landing sites in Gusev Crater, Utopia Planitia, and Chryse Planitia.

Thermal infrared data analyses of Meteor Crater, Arizona: Implications for Mars spaceborne data from the Thermal Emission Imaging System

Thermal infrared (TIR) data from the Earth‐orbiting Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) instrument are used to identify the lithologic distribution of the Meteor Crater ejecta blanket. Thermal emission laboratory spectra were obtained for collected samples, and spectral deconvolution was performed on ASTER emissivity data using both image and sample end‐members. Comparison of the spaceborne ASTER data to the airborne Thermal Infrared Multispectral Scanner (TIMS) data was used to validate the ASTER end‐member analyses. The ASTER image end‐member analysis agrees well with past studies considering the effects of resolution degradation. The work at Meteor Crater has direct bearing on the interpretation of Thermal Emission Imaging System (THEMIS) data currently being returned from Mars. ASTER and THEMIS have similar spatial and spectral resolutions, and Meteor Crater serves as an analog for similar‐sized impact sites on Mars. These small impact craters have not been studied in detail owing to the low spatial resolution of past orbiting TIR instruments. Using the same methodology as that applied to Meteor Crater, THEMIS TIR data of a provisionally named Winslow Crater (∼1 km) impact crater in Syrtis Major are analyzed. The crater rim and ejecta blanket were found to contain larger block sizes and a lower albedo than the surrounding ejecta‐free plain, indicating a young impact age. The composition of the rim, ejecta, and surrounding plain is determined to be dominated by basalt; however, potential stratigraphy has also been identified. Results of this work could be extended to future investigations using THEMIS data.

Identification of quartzofeldspathic materials on Mars

A unique spectral component has been identified near and on the central peaks of two 30 km diameter craters in northern Syrtis Major. These exposures are clearly visible in Thermal Emission Imaging System (THEMIS) color radiance images as well as THEMIS and Thermal Emission Spectrometer (TES) surface emissivity data. Both TES and THEMIS data indicate the presence of increased 1050–1250 cm−1 (∼8–9.5 μm) absorption compared to the surrounding basaltic plains, and TES data also display other absorptions at 400, 470, and 800 cm−1 (∼25, 20, and 12 μm) consistent with the presence of quartz. Ratio and isolated central peak spectral unit spectra match laboratory emissivity spectra of granitoid rocks composed primarily of quartz and plagioclase feldspar. Deconvolution results also indicate that the surface contains quartz and feldspar in addition to a high‐Si glass and/or sheet silicate component. Because central peak materials are brought up from depth during the cratering event, the association of the quartzofeldspathic mineralogy with the central peaks of the craters indicates that the quartz‐bearing material was excavated from depth. The occurrence in the two adjacent craters may imply a granitoid pluton of considerable extent. A plausible formation mechanism for this relatively silicic material may be similar to that of terrestrial trondhjemites, which do not require plate tectonics. The rarity of the exposures implies that the process that formed the granitoid composition was probably not widespread. The presence of quartz‐bearing material on Mars indicates that mechanisms that produce highly differentiated magmas have been present and extends the diversity of surface compositions identified.

Surficial properties in Gale Crater, Mars, from Mars Odyssey THEMIS data

We examine the nature of the surface layer in Gale Crater as determined from high-resolution thermal and visible Mars Odyssey Thermal Emission Imaging System (THEMIS) data as well as how our conclusions compare to past analyses. At THEMIS resolution, the thermal surface structure is dominated by local control, thus providing us with detailed images that contain thermophysical information as well. Using these data sets we have created a map of the area, defining units based primarily on their geomorphology as determined from the daytime thermal and visible images and then using the nighttime thermal data to interpret the nature of the surface layer within each unit. Seven units have been defined: (i) partially blanketed knobby plateaus, (ii) crater walls with terrain similar to that on the plateaus on the upper half and exposed, rocky surfaces on the lower half, (iii)–(v) three floor units with varying combinations of bedrock and indurated and/or particulate deposits, (vi) sand sheets, and (vii) a central mound, consisting of indurated and/or rocky material forming layers, terraces, and slides, covered by particulate material that tapers in thickness downslope. Additionally, dozens of channels have been observed on the crater walls and central mound. The results indicate that aeolian processes have played a major role in shaping much of the present surface layer within Gale and may still be active today. Because of the dramatic size and structure of Gale, the winds are most likely controlled by the local topography. Additionally, the presence and frequency of channels within Gale bolster hypotheses involving aqueous episodes in the history of the crater.