Switchable Dual-wavelength Erbium-doped Fiber Laser Research Articles

Switchable dual-wavelength erbium-doped fiber laser based on the broadband filtering performance of tapered long period fiber gratings

In this paper, a switchable, dual-wavelength erbium-doped fiber laser, based on the broadband filtering performance of a tapered long-period fiber grating, is experimentally demonstrated. The lasing emission can be built up in sets of dual-wavelengths in the entire C-band, with variable and controllable separation between laser lines from 6.75 nm to 35 nm when the optical fiber filter structure is gradually bent.

A switchable dual-wavelength fiber laser based on phase-shifted fiber Bragg grating combined with Sagnac loop

A switchable dual-wavelength erbium-doped fiber (EDF) laser is proposed and demonstrated. The interference filter is achieved by employing a phase-shifted fiber Bragg grating (PSFBG) combined with Sagnac loop structure. By adjusting polarization controller (PC) states, the birefringence effect is introduced to weaken mode competition, then stable and switchable dual-wavelength fiber laser can be realized. Based on coupled-mode theory and transmission matrix, the Sagnac loop transmission characteristics are studied. The experimental results show that the proposed fiber laser can operate in switchable dual-wavelength output mode at room temperature just by simply adjusting PC. The output wavelength range of fiber laser is 1 556.128–1 556.384 nm, the side mode suppression ratio (SMSR) is over 45 dB, and dual-wavelength spacing as small as 0.048 nm is achieved, which can be used in high-fineness dense wavelength division multiplexing (DWDM) systems and similar structures.

Switchable dual-wavelength fiber laser based on a phase-shifted fiber Bragg grating combined with Mach-Zehnder interferometer and Sagnac loop

Abstract A switchable dual-wavelength erbium-doped fiber laser is proposed and demonstrated. It is based on the finer filter effect of phase-shifted fiber Bragg grating (PSFBG), combining with the compound interference filtering effect of Mach-Zehnder interferometer (MZI) and Sagnac loop. By adjusting the polarization controller (PC) and tuning the delay, the switchable single- and dual-wavelength fiber laser with tunable wavelength spacing can be obtained. As a result, the dual-wavelength spacing as small as 0.04 nm is achieved, the output wavelength is from 1555.580 nm to 1559.928 nm, and the side mode suppression ratio (SMSR) is larger than 40 dB. The maximum wavelength drift of single-wavelength is less than 0.033 nm, and the maximum fluctuation of dual-wavelength is less than 0.02 nm. The experimental results show that the proposed fiber laser has important applications, such as in high fineness dense wavelength division multiplexing (DWDM) systems and other similar fields.

Tunable and switchable dual-wavelength erbium-doped fiber laser based on in-line tapered fiber filters

A tunable and switchable dual-wavelength erbium-doped fiber laser (EDFL) based on all-fiber single-mode tapered fiber structure has been demonstrated. By adjusting the variable optical attenuator (VOA), the laser can be switched between the single-wavelength mode and the dual-wavelength mode. When the temperature applied on the tapered fiber structure varies, the pass-band varies and the wavelength of the output laser shifts correspondingly. When the temperature changes from 30 °C to 180 °C, the central wavelength of the EDFL generated by branch A shifts from 1 550.7 nm to 1 560.3 nm, while that of branch B shifts from 1 530.8 nm to 1 540.4 nm, indicating the wavelength interval is tunable. These advantages enable this laser to be a potential candidate for high-capacity wavelength division multiplexing systems and mechanical sensors.

Switchable dual-wavelength erbium-doped fiber laser with tunable wavelength

A switchable dual-wavelength erbium-doped fiber laser (EDFL) with tunable wavelength is demonstrated. The ring cavity consists of two branches with a fiber Bragg grating (FBG) and a spherical-shape structure as fiber filters, respectively. By adjusting the variable optical attenuator (VOA), the laser can be switched between the single-wavelength mode and the dual-wavelength mode. The spherical-shape structure has good sensitivity to the temperature. When the temperature changes from 30 °C to 190 °C, the central wavelength of the EDFL generated by the branch of spherical-shape structure varies from 1 551.6 nm to 1 561.8 nm, which means that the wavelength interval is tunable.

A switchable dual-wavelength erbium-doped fiber laser based on saturable absorber and active optical fiber ring filter

A dual-wavelength erbium-doped fiber laser (EDFL) with outstanding stability is presented. In the fiber laser system, two nested active optical fiber ring filters are configured to improve the comb spectrum performance, a saturable absorber is employed to form a gain grating for both filtering and frequency stabilizing, two cascaded fiber Bragg gratings (FBGs) are utilized to achieve dual-wavelength output, and a variable attenuator is arranged to adjust output power. Experimental results illustrate that the peak wavelength drift is less than 3 pm, and a good linear relationship between output power and pump power is realized.

Tunable and switchable dual-wavelength single polarization narrow linewidth SLM erbium-doped fiber laser based on a PM-CMFBG filter.

A tunable and switchable dual-wavelength single polarization narrow linewidth single-longitudinal-mode (SLM) erbium-doped fiber (EDF) ring laser based on polarization-maintaining chirped moiré fiber Bragg grating (PM-CMFBG) filter is proposed and demonstrated. For the first time as we know, the CMFBG inscribed on the PM fiber is applied for the wavelength-tunable and-switchable dual-wavelength laser. The PM-CMFBG filter with ultra-narrow transmission band (0.1 pm) and a uniform polarization-maintaining fiber Bragg grating (PM-FBG) are used to select the laser longitudinal mode. The stable single polarization SLM operation is guaranteed by the PM-CMFBG filter and polarization controller. A tuning range of about 0.25 nm with about 0.075 nm step is achieved by stretching the uniform PM-FBG. Meanwhile, the linewidth of the fiber laser for each wavelength is approximate 6.5 and 7.1 kHz with a 20 dB linewidth, which indicates the laser linewidth is approximate 325 Hz and 355 Hz FWHM.

A switchable dual-wavelength erbium-doped fiber laser based on Sagnac loop inserted with two FBGs

A novel switchable dual-wavelength erbium-doped fiber (EDF) laser is demonstrated. The wavelength selection element consists of two fiber Bragg gratings (FBGs), a polarization controller (PC) and a 3 dB coupler forming a Sagnac loop inserted with two FBGs. We study the effect of coupling ratio on filtering performance in this paper. By adjusting PC, we can change the wavelength-dependent loss, and then using nonlinear polarization rotation effect to suppress the mode competition caused by the homogeneous broadening of EDF, we obtain single- and double-wavelength laser outputs. At room temperature, under 200 mW pump power, dual-wavelength laser is achieved, and the center wavelengths are 1545.34 nm and 1548.20 nm, respectively. The peak power values are −13.36 dBm and −14.58 dBm, and side mode suppression ratios (SMSRs) are 41.10 dB and 39.88 dB, respectively. Within two hours, the maximum fluctuation of peak power is less than 0.7 dB, which shows that the demonstrated fiber laser is stable. Moreover, by adjusting PC, singel-wavelength laser output is obtained, the peak power is −6.27 dBm or −5.45 dBm, and SMSR is 40.03 dB or 39.96 dB at 1545.34 nm or 1548.20 nm, respectively.

A 100 mW-level single-mode switchable dual-wavelength erbium-doped fiber laser

A switchable dual-wavelength CW erbium-doped fiber laser with two cascaded fiber Bragg gratings has been proposed and demonstrated experimentally at room temperature. The laser uses a linear resonant cavity configuration incorporating a Sagnac loop with a polarization controller (PC) and can switch flexibly to output a single wavelength or dual wavelengths based on the polarization hole burning (PHB) effect. The slope efficiency and maximum output power can reach 23% and 96 mW, respectively. The two lasing peaks of the laser, with a narrow linewidth output and an optical signal-to-noise ratio of more than 50 dB, are located in the C and L bands of the optical communication window, respectively. The laser shows good stability with respect to the wavelength and output power.

Switchable dual-wavelength erbium-doped fiber laser based on polarization-maintaining fiber Sagnac loop mirror and fiber Bragg gratings

A switchable dual-wavelength erbium-doped fiber laser is proposed and experimentally demonstrated, which is constructed by a polarization-maintaining fiber Sagnac loop mirror (PMF-SLM) and two FBGs with different wavelengths. Wavelength switching operation is achieved by properly adjusting the polarization controller (PC) in the PMF-SLM. Stable single- or dual-wavelength lasing output can be realized. The maximum amplitude variation for every lasing wavelength is less than 1 dB, and the signal-to-amplified spontaneous emission (ASE) ratio is about 35 dB.

Switchable dual-wavelength single-longitudinal-mode erbium-doped fiber laser using an inverse-Gaussian apodized fiber Bragg grating filter and a low-gain semiconductor optical amplifier

We present a stable and switchable dual-wavelength erbium-doped fiber laser. In the ring cavity, an inverse-Gaussian apodized fiber Bragg grating serves as an ultranarrow dual-wavelength passband filter, a semiconductor optical amplifier biased in the low-gain regime reduces the gain competition of the two wavelengths, and a feedback fiber loop acts as a mode filter to guarantee a stable single-longitudinal-mode operation. Two lasing lines with a wavelength separation of approximately 0.1 nm are obtained experimentally. A microwave signal at 12.51 GHz is demonstrated by beating the dual wavelengths at a photodetector.

Switchable dual-wavelength polarization-maintaining erbium-doped fiber laser using an optical circulator as the all-reflecting mirror

A simple and effective switchable dual-wavelength polarization-maintaining erbium-doped fiber laser is proposed and demonstrated. Only using a uniform fiber Bragg grating written directly in a segment of the photosensitive and polarization-maintaining erbium-doped fiber as the wavelength selector and an optical circulator as the all-reflecting mirror, a stable simultaneous dual-wavelength oscillation is achieved with a wavelength spacing of 0.364 nm experimentally by exploiting the polarization hole burning effect at room temperature. The output can be switched between single- and dual-wavelength by adjusting the polarization controller. The 3-dB bandwidth and the side mode suppression ratio of the laser’s outputs are measured to be less than 0.01 nm and more than 50 dB. The power fluctuation and wavelength drift are measured to be less than 0.50 dB and 0.020 nm over an hour.

Switchable dual-wavelength erbium-doped fiber laser based on the photonic crystal fiber loop mirror and chirped fiber Bragg grating

The switchable dual-wavelength erbium-doped fiber laser (EDFL) with a two-mode photonic crystal fiber (PCF) loop mirror and a chirped fiber Bragg grating (CFBG) at room temperature is proposed and experimentally demonstrated. The two-mode PCF loop mirror is formed by inserting a piece of two-mode PCF into a Sagnac loop mirror, with the air-holes of the PCF intentionally collapsing at the splices. By adjusting the state of the polarization controller (PC) appropriately, the laser can be switched between the stable single- and dual-wavelength operations by means of the polarization hole burning (PHB) and spectral hole burning (SHB) effects.

Single-polarization, switchable dual-wavelength erbium-doped fiber laser with two polarization-maintaining fiber Bragg gratings

An improved erbium-doped fiber laser configuration for achieving single-polarization, switchable dual-wavelength of orthogonal polarizations oscillations at room temperature is proposed. For the first time, two fiber Bragg gratings (FBGs) directly written in a polarization-maintaining (PM) and photosensitive erbium-doped fiber (PMPEDF) as the wavelength-selective component are used in a linear laser cavity. Due to the polarization hole burning (PHB) enhanced by the polarization-maintaining FBG (PMFBG), the laser can be designed to operate in stable dual-wavelength or wavelength-switching modes with a wavelength spacing of 0.336 nm at room temperature by adjusting a polarization controller (PC). Each lasing line shows a single polarization with a polarization extinction ratio of >25 dB under different pump levels. The optical signal-to-noise ratio (OSNR) is greater than 50 dB. The amplitude variation with 16 times scans in nearly one and half an hour is less than 0.5 dB at both operating wavelength.

A microwave photonic filter using a switchable multiple dual-wavelength erbium-doped fiber laser

A multi-tap microwave photonic filter is proposed and experimentally demonstrated. The filter is based on a switchable multiple dual-wavelength erbium-doped fiber laser with a narrowband polarization maintaining (PM) Fabry–Perot filter (FPF) as the wavelength selection component. The tunability feature of the filter is also demonstrated through switching of the laser between multiple dual-wavelengths and a normal multiwavelength laser.

Switchable dual-wavelength erbium-doped fiber laser with a tilted fiber grating

A dual-wavelength erbium doped fiber laser with a tilted fiber Bragg grating and photonic crystal fiber is proposed and demonstrated. In the laser, a 2W EDFA provides gain for all the laser lines; the highly nonlinear photonic crystal fiber introduces dynamic energy transfer between the two wavelengths caused by four wave mixing effect, so that a stable dual-wavelength oscillation at room temperature is implemented. Different switching modes can be achieved by adjusting the lateral offset between the fiber grating and the guiding single mode fiber or by varying the state of polarization in the laser cavity. The maximum of output power of the laser has reached 314mW.

Switchable and tunable dual-wavelength erbium-doped fiber laser based on one fiber Bragg grating

Switchable and tunable dual-wavelength erbium-doped fiber laser based on one fiber Bragg grating

L-Band switchable dual-wavelength erbium-doped fiber laser based on a multimode fiber Bragg grating

In this letter, a simple, switchable dual-wavelength erbiumdoped fiber laser operating in L-band is successfully proposed and demonstrated. The two wavelengths are specified by a Bragg grating formed in multimode fiber and the wavelength separation is 1.7 nm. The multimode section including the multimode fiber grating selects not only the lasing wavelengths but also the polarization states of the lasing lines. Stable dualwavelength operation can be achieved due to the spatial mode beating effect induced by a single-mode /multimode/ single-mode fiber combination structure. By simple adjustment of a polarization controller, the proposed laser can operate in stable dual-wavelength or switch between two wavelengths, all at room temperature.