Study Of Thermal State Research Articles

Study of thermal state, water absorption and strength properties of composite polymerpolymer binders

In this article, in order to improve the heat-water resistance and strength properties, the modification of urea-formal- dehyde polymeric materials is considered by introducing melamine and acrylonitic resins and reactive compounds into their composition. Shown by identifying the optimal ratios of urea-formaldehyde, melamine and acrylonitrile resins and the corresponding reactive compounds in increasing the heat-water resistance and shear strength of adhesive joints based on them, replacing expensive phenol-formaldehyde resins used in gluing basalt fibrous masses in the production of build- ing heat-insulating sheet materials.

Study of rollers thermal state at hot rolling of long products profiles at 370/150 mill of OJSC “Belorussky steel-works – UKKh “Belorusskaya metallurgical company”

In the rolling production, rolls with box passes are widely used, which is explained by the best gripping ability and high draw ratio. However, along with these advantages, there are significant drawbacks - the formation of an erosion net along the bottom of the pass and side cracks on the side outlets, since hot rolling of metals and alloys is accompanied by intense wear of the working rollers and welding fixtures, which happens due to exposure to high temperatures and stresses. Therefore, the task of elaboration of rational temperature regime to provide not only stable mill operation, but also high rollers endurance, is rather actual and requires its solution. It is very important to follow the today’s trend to increase continuous mills rolling speed, which will result in still heavier temperature conditions of rollers operation. Results of the study of the rolling process main technological parameters influence on the formation of erosion net across the bottom of the pass presented, as well as magnitude and nature of the distribution of thermal cyclic stresses along the surface layers of the bottom of pass. Study of the thermal state of roughing stands rollers of OJSC “Belorussky steel-works” 370/150 continuous wire-rod mill show, that comparing with intermediate and finished stands rollers they subject more to thermo-cyclic destruction of passes surface, but not to mechanical one. As a result of the computer simulation new data obtained on the character and peculiarities of dynamics of surface thermal state of rollers passes. The possibilities to reduce thermal cyclic stresses by improving the cooling regime of the rolls shown. Using the simulation by the finite elements method, the study of the dynamics of heating and stress state of the surface and subsurface layers of the pass bottom was accomplished. Based on the analysis results of numerical experiments and analytical calculations, isotherms of the surface layers of the bottom of the pass were compiled to select the optimal cooling mode. The data obtained can be used to control the cooling systems of roughing stands rollers of continuous section and pipe hot rolling mills.

HEAT MONITORING OF HEATING SYSTEM PROTECTION OF A NEW PASSENGER TERMINAL OF THE SAMARA INTERNATIONAL AIRPORT «KURUMOCH»

The results of experimental studies of thermal state of heat transport lines are viewed. Ready-to-use PU foarm unsulation in polyethylene sheath is taken as thermal insulation of heating system lines under the ground. Readyto- use PU foarm unsulation in sheet galvanized steel sheath is taken as thermal insulation of heating system lines aboveground. Experimental results permit to determine real heat losses of heat transport systems.

Development of procedure for and results from calculated study of thermal state of turbine first-stage nozzle vanes and efficiency of their convective-film air cooling

Information on the development of a comprehensive procedure for calculating a nozzle vane with convective-film cooling and on its hydraulic, thermal, and strength characteristics is presented.