Stress Distribution In Adhesive Layer Research Articles

Analytical investigation of thermal and mechanical load effects on stress distribution in adhesive layer of double-lap metal-composite bonded joints

Significant thermal stresses are induced in the adhesive layers of a metal-composite bonded joint owing to the large temperature change associated with the difference in the coefficients of thermal expansions of metals and composite adherends. In this study, a theoretical analysis of shear and peel stresses in adhesive layers of a double-lap metal-composite bonded joint is carried out to evaluate the effects of thermal and mechanical loads on the stress distribution in the adhesive layer. The effects of temperature change and adhesive thickness on the shear and peel stresses in the adhesive layer of the bonded joint, with and without external forces, are examined based on the theoretical analysis. The results calculated for the condition involving a mechanical load application to the bonded joint and a decrease in temperature indicate that the absolute value of the shear and peel stresses peak at both ends of the adhesive layer, and that the absolute value of the peak stresses increases in the case of a thinner adhesive layer. When mechanical and thermal loads are simultaneously applied to a double-lap joint, shear and peel stresses synergistically increase at one end of the adhesive layer and decrease with an offset at the other end.

Analytical Investigation of Thermal and Mechanical Load Effects on Stress Distribution in Adhesive Layer of Double-lap Metal–Composite Bonded Joints

Analytical Investigation of Thermal and Mechanical Load Effects on Stress Distribution in Adhesive Layer of Double-lap Metal–Composite Bonded Joints

Stress Distribution in Single Lap Joints with a Cracked Composite Adherend—Part II: Laminated Adherends

The effect of a crack in the overlap region of an adhesive single lap joint is studied on the shear stress distribution in adhesive layer. Each adherend is considered to be a laminated composite material with unidirectional fibers aligned in the direction of the applied load. Crack location is selected to be in the top adherend laminate, in the form of cut fibers and matrix bays. The crack can occur in any layer. The shear-lag model is used to derive the equilibrium equations which are then solved by means of eigenvector expansion. The effects of adhesive thickness, crack size, and location in the adherend, total number of layers in each adherends, volume fraction of fibers, and type of fibers are investigated on the shear distribution in the adhesive as well as load distribution in the intact fiber at the crack tip located in the top adherend. The effect of dissimilar laminated adherends is also investigated on the adhesive shear stress distribution. According to the results, in the presence of a crack, the peak shear stress in the adhesive layer and load concentration in the fibers are very susceptible to the adhesive thickness and number of layers in laminated adherends.