Solvent-cast Printing Research Articles

Solvent‐Cast 3D Printing of Biodegradable Polymer Scaffolds

Abstract3D printing is a popular fabrication technique because of its ability to produce complex architectures. Melt‐based 3D printing is widely used for thermoplastic polymers like poly(caprolactone) (PCL), poly(lactic acid) (PLA), and poly(lactic‐co‐glycolic acid) (PLGA) because of their low processing temperatures. However, traditional melt‐based techniques require processing temperatures and pressures high enough to achieve continuous flow, limiting the type of polymer that can be printed. Solvent‐cast printing (SCP) offers an alternative approach to print a wider range of polymers. Polymers are dissolved in a volatile solvent that evaporates during deposition to produce a solid polymer filament. SCP, therefore, requires optimizing polymer concentration in the ink, print pressure, and print speed to achieve desired print fidelity. Here, capillary flow analysis shows how print pressure affects the process‐apparent viscosity of PCL, PLA, and PLGA inks. Ink viscosity is also measured using rheology, which is used to link a specific ink viscosity to a predicted set of print pressure and print speed for all three polymers. These results demonstrate how this approach can be used to accelerate optimization by significantly reducing the number of parameter combinations. This strategy can be applied to other polymers to expand the library of polymers printable with SCP.

Additive Manufacturing of Mechanically Isotropic Thin Films and Membranes via Microextrusion 3D Printing of Polymer Solutions

Polymer extrusion additive manufacturing processes, such as fused filament fabrication (FFF), are now being used to explore the fabrication of thin films and membranes. However, the physics of molten polymer extrusion constrains achievable thin film properties (e.g., mechanical isotropy), material selection, and spatial control of film composition. Herein, we present an approach for fabrication of functional polymer thin films and membranes based on the microextrusion printing of polymer solutions, which we refer to as "solvent-cast printing" (SCP). Constructs fabricated via SCP exhibited a 43% reduction in anisotropy of tensile strength relative to those fabricated using FFF. The constructs fabricated via SCP exhibited a lesser extent of visible layering defects relative to those fabricated by FFF. Further, the swelling dynamics of the films varied depending on the membrane fabrication technique (i.e., SCP vs manual drop casting). The opportunity for expanding material selection relative to FFF processes was demonstrated by printing poly(benzimidazole), a high-performance thermoplastic with high glass-transition temperatures ( Tg ∼ 400 °C). Results from this work indicate that our new approach could facilitate the manufacture of mechanically isotropic thin films and membranes using currently unprintable high-performance thermoplastics.