Solution Of Natural Convection Flow Research Articles

Semi-Analytical Solution of Natural Convection Flow of Non-Newtonian Fluid With Temperature-Dependent Viscosity In Pipe

Abstract: This paper presents semi-analytical solution of natural convection flow of non-newtonian fluid with temperaturedependent viscosity in pipe. The governing equations were solved using perturbation technique. The results obtained were analyzed for various thermo-solutal parameters involved in the dimensionless equations. Results within the constant viscosity show that increase in these parameters increases the velocity of the fluid flow as well as the temperature of the cylindrical pipe. It is observed that increase in the Reynold’s viscosity indices increases the temperature of the cylindrical pipe greatly.

Numerical solution for natural convection flow near a vertical porous plate having convective boundary condition with nonlinear thermal radiation

AbstractThis article presents the theoretical study of the effects of suction/injection and nonlinear thermal radiation on boundary layer flow near a vertical porous plate. The importance of the convective boundary condition as regards the heat transfer rate is taken into account. The coupled nonlinear boundary layer equations are translated into a set of ordinary differential equations via a similarity transformation. The consequences of the active parameters like the suction parameter, injection parameter, convective heat transfer parameter, nonlinear thermal radiation parameters, and Grashof number dictating the flow transport are examined. The numerical result obtained shows that with suction/injection, the heat transfer rate could be increased with nonlinear thermal radiation parameter augment whereas decays with the convective heat transfer parameter and Grashof number. In the presence of suction/injection, the wall shear stress generally increases with nonlinear thermal radiation parameter, convective heat transfer parameter, and Grashof number. The suction has an increasing effect on Nusselt number and shear stress whereas a decreasing effect on Nusselt number and skin friction is seen with injection augment. The nonlinear thermal radiation is an increasing function of the temperature gradient far away from the plate whereas a decreasing function near the porous plate.

A Similarity Solution for Natural Convection Flow near a Vertical Plate with Thermal Radiation

This paper examined the fluid transport on boundary layer near a vertical wall with thermal radiation effect. The coupled nonlinear partial differential equations are reduced to a system of ordinary differential equations through similarity transformation. The resultant system of ordinary differential equations is integrated with maple software using RKF45 method. The effect of the active parameters such as Grashof number, thermal radiation parameter, temperature difference, Prandtl number, and local convective heat transfer parameter on the velocity profile, skin friction, temperature profile and Nusselt number are presented using graphs and tables. The outcome of the study revealed that the Prandtl number has a decreasing effect on thermal boundary layer thickness. It also revealed that the thermal radiation has an increasing effect on the Nusselt number, temperature distribution, temperature gradient and skin friction. The temperature distribution increases with increasing values of the temperature difference and local convective heat transfer parameter whereas decreases with Grashof number.

Natural convection flow in a vertical annulus with time-periodic thermal boundary conditions

This paper presents an analytical solution for natural convection flow in a vertical annulus due to time-periodic heating of annulus surfaces. Closed-form expressions for velocity, temperature, skin-friction, mass flow rate and rate of heat transfer which is expressed as Nusselt number are obtained by solving the present mathematical model after separating into steady component and periodic regime. The effects of pertinent parameters such as Strouhal number (St), Prandtl number (Pr) and radius ratio (λ) are shown with the aid of contour and line graphs. Results indicate that the role of Strouhal number and Prandtl number is to decrease fluid velocity, temperature and skin-friction. Furthermore, increase in Strouhal number increases the temperature phase-lag.

A Computational Solution of Natural Convection Flow in a Rotating Fluid with Radiative Heat Transfer

An analysis of the hydromagnetic free convective flow past a vertical infinite porous plate in a rotating fluid is carried out. The temperatures involved are assumed to be very large so that the radiative heat transfer is significant, which renders the problem very non-linear even on the assumption of a differential approximation for the radiative flux. The temperature and velocity fields are computed using a generic software tool based on the Nakamura finite difference scheme. The genericity of the software tool is in the sense that it is a common solution to the category of time dependent laminar fluid flows expressed in one spatial coordinate. The input equations, together with other relevant parameters, are transformed into postfix code which will be farther interpreted in the computation process. The influence of the various parameters entering into the problem is shown graphically followed by a discussion of results.

FEM solution of natural convection flow in square enclosures under magnetic field

PurposeThe purpose of the paper is to obtain finite element method (FEM) solution of steady, laminar, natural convection flow in inclined enclosures in the presence of an oblique magnetic field. The momentum equations include the magnetic effect, and the induced magnetic field due to the motion of the electrically conducting fluid is neglected. Quadratic triangular elements are used to ensure accurate approximation for second order derivatives of stream function appearing in the vorticity equation.Design/methodology/approachGoverning equations in terms of stream function and vorticity are solved by FEM using quadratic triangular elements. Vorticity boundary conditions are obtained through Taylor series expansion of stream function equation by using more interior stream function values to improve the accuracy. Isothermally heated or cooled and/or adiabatic conditions for the temperature are imposed. Results are obtained for Rayleigh number values and Hartmann number values up to 1000000 and 100, respectively.FindingsIt is observed that streamlines form a thin boundary layer close to the heated walls as Ha increases. The same effect is seen in the vorticity contours, and isotherms are not affected much. As Ra increases streamlines are deformed moving from the heated walls through cooled walls. Vorticity starts to develop boundary layers close to heated and adjacent walls. Isotherms are pushed towards the sinusoidally heated wall whereas in the case of linearly heated left and bottom walls they expand towards cooled part of the cavity as Ra increases.Originality/valueThe application of FEM with quadratic elements for solving natural convection flow problem under the effect of a magnetic field is new in the sense that the results are obtained for large values of Rayleigh and Hartmann numbers.

Analytical Solution of Natural Convection Flow in Vertical Concentric Annuli with Internal Heat Generation/Absorption

Analytical Solution of Natural Convection Flow in Vertical Concentric Annuli with Internal Heat Generation/Absorption

Analytical solution of natural convection flow of a nanofluid over a linearly stretching sheet in the presence of magnetic field

In this paper, we examine the convective flow and heat transfer of an incompressible viscous nanofluid past a semi-infinite vertical stretching sheet in the presence of a magnetic field. The governing partial differential equations with the auxiliary conditions are reduced to ordinary differential equations with the appropriate corresponding conditions via scaling transformations. The analytical solutions of the resulting ODEs are obtained, and from which the analytical solutions of the original problem are presented. The influence of pertinent parameters such as the magnetic parameter, the solid volume fraction of nanoparticles and the type of nanofluid on the flow, heat transfer, Nusselt number and skin friction coefficient is discussed. Comparison with published results is presented.

Analytic solution of natural convection flow of a non-newtonian fluid between two vertical flat plates by using decomposition method

An analysis has been performed to study the natural convection of a non-Newtonian fluid between two infinite parallel vertical flat plates and the effects of the non-Newtonian nature of fluid on the heat transfer are studied. The governing boundary layer and temperature equations for this problem are reduced to an ordinary form and are solved by Adomian decomposition method (ADM) and numerical method. Velocity and temperature profiles are shown graphically. The obtained results are valid for the whole solution domain with high accuracy. These methods can be easily extended to other linear and non-linear equations and so can be found widely applicable in engineering and science. © 2010 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq 27: 1384–1395, 2010

DRBEM solution of natural convection flow of nanofluids with a heat source

This paper presents the dual reciprocity boundary element method (DRBEM) solution of the unsteady natural convective flow of nanofluids in enclosures with a heat source. The implicit Euler scheme is used for time integration. All the convective terms are evaluated in terms of DRBEM coordinate matrix. The vorticity boundary conditions are obtained from the Taylor series expansion of stream function equation. The results report that the average Nusselt number increases with the increase in both volume fraction and Rayleigh number. It is also observed that an increase in heater length reduces the heat transfer. The average Nusselt number of aluminum oxide-water based nanofluid is found to be smaller than that of copper-water based nanofluid. Results are given in terms of streamlines, isotherms, vorticity contours, velocity profiles and tables containing average Nusselt number for several values of Rayleigh number, heater length, volume fraction, and number of iterations together with CPU times.

Approximate Series Solution of Natural Convection Flow in the Presence of Radiation

Approximate Series Solution of Natural Convection Flow in the Presence of Radiation

Analytic solution of natural convection flow of a non-Newtonian fluid between two vertical flat plates using homotopy analysis method

An analysis has been performed to study the natural convection of a non-Newtonian fluid between two infinite parallel vertical flat plates and the effects of the non-Newtonian nature of fluid on the heat transfer are studied. The governing boundary layer and temperature equations for this problem are reduced to an ordinary form and are solved by homotopy analysis method (HAM), and numerical method. Velocity and temperature profiles are shown graphically. The obtained results are valid for the whole solution domain with high accuracy. These methods can be easily extended to other linear and non-linear equations and so can be found widely applicable in engineering and sciences.

Investigation of a large top wall temperature on the natural convection plume along a heated vertical wall in a square cavity

The characteristics of the laminar natural convection in an air-filled square cavity heated and cooled on the side walls was studied for cases where the temperature of the top wall was significantly larger than the heated vertical wall. Experiments were performed for a horizontal Grashof number of 1.3×108, and non-dimensional top wall temperatures from 1.4 to 2.3. The results show that the plume formed on the heated vertical wall separated from this wall before reaching the top wall. As a result, three different regions were observed in the cavity: a stratified core region, a buoyant plume region, and a highly stratified region above the plume after it had separated from the vertical wall. The highly stratified region above the plume became larger and more stable with an increase of the top wall temperature, stabilizing the motion of the plume across the cavity. The similarity solutions developed by Kulkarni et al. [A.K. Kulkarni, H.R. Jacobs, J.J. Hwang, Similarity solution for natural convection flow over an isothermal vertical wall immersed in thermally stratified medium, Int. J. Heat Mass Transfer 30 (1987) 691–698] to characterize the natural convection heat transfer along an isothermal single vertical plate did not agree with the results for the current measurements; however, the non-similarity model of Chen and Eichhorn [C.C. Chen, R. Eichhorn, Natural convection from a vertical surface to thermally stratified fluid, J. Heat Transfer 98 (1976) 446–451] was in good agreement over most of the wall. There were some discrepancies in the temperature distributions and the heat transfer characteristics, especially at y/H⩾0.8 due to the separated flow in this region.

Similarity solution for natural convection flow over an isothermal vertical wall immersed in thermally stratified medium

A similarity solution has been obtained for a natural convection flow on a heated isothermal wall suspended in a quiescent, thermally stratified atmosphere. A new similarity variable is defined which reduces to that for the classical case of an isothermal plate in a uniform temperature, quiescent medium. It also properly represents the case for an isothermal plate in a linear stably stratified atmosphere. This is a unique feature which has not been discussed before. Predicted values of the local temperature defect and flow reversal are in qualitative agreement with results obtained by earlier investigators.

Numerical solution of natural convection flow past a non-isothermal vertical flat plate

The problem of natural convection over a semi-infinite flat plate with non-uniform wall temperature is studied by using a numerical method. The local rates of heat transfer as a function of the distance along the plate are tabulated for a range of Prandtl numbers (0.01 to 100) and for a few cases of wall temperature distributions. Such tabulations serve as a reference against which other approximate solutions can be compared in the future.