Slot-scanning System Research Articles

A phantom study on dose efficiency for orthopedic applications: Comparing slot-scanning radiography using ultra-small-angle tomosynthesis to conventional radiography.

This paper studies the abilities of a twin-robotic x-ray slot-scanning system for orthopedic imaging to reduce dose by scatter rejection compared to conventional digital radiography. We investigate the dose saving capabilities, especially in terms of the signal- and the contrast-to-noise ratio, as well as the scatter-to-primary ratio of the proposed slot-scanning method in comparison to the state-of-the-art method for length-extended imaging. As a baseline, we use x-ray parameters of two clinically established acquisition protocols that provide the same detector entrance dose but are profoundly different in patient dose. To obtain an estimate of the photon-related noise directly from an x-ray image, we implement a Poisson-Gaussian noise model. This model is used to compare the dose efficiency of two settings and combined with the well-known to determine the transmission parameters. We present a method with an associated measurement protocol, utilizing the robotic capabilities of the used system to automatically obtain quasi-scatter-free ground-truth data with exact geometric correspondence to full-field and slot acquisitions. In total, we investigate two body regions (thoracic spine and lumbar spine) in anterior-posterior view with two patient sizes (BMI = 22 and 30) in two acquisition modes (conventional and slot scan with a flat-panel detector) with and without anti-scatter grid using an anthropomorphic upper-body phantom. We have shown that it is feasible to combine the proposed approach with the for the determination of scatter rejection parameters. The use of an anti-scatter grid is indicated for full-field acquisitions allowing for dose savings up to 46% compared to their gridless counterparts. When changing the acquisition mode to the investigated slot scan, the use of an anti-scatter grid has no major impact on the image quality in terms of dose efficiency, in particular for patients with a BMI of 22. However, an increased contrast improvement factor was found. For normal-sized patients, up to 53% of dose can be saved additionally in comparison to full-field acquisitions with grid. Moreover, we could demonstrate that a slot size of 5cm and air gap of 10cm is sufficient to achieve scatter-to-primary ratios, which are equal or better compared to those of the full-field acquisitions with a grid. We have shown, that the slot-scanning approach is always superior to the conventional full-field acquisition in terms of signal-to-noise and scatter-to-primary ratios. Compared to the state-of-the-art acquisition protocols with a grid, dose savings up to 53% are possible due to the scatter rejection without compromising the SNR. Hence, the use of the slot-scanning method is indicated, especially when it comes to regularly carried-out follow-up acquisitions, for example, in the case of scoliosis monitoring.

Radiographic signs of acetabular retroversion using a low-dose slot-scanning radiographic system (EOS®)

IntroductionAcetabular retroversion is assessed using pelvic X-ray. Cross-over-sign (COS), posterior-wall-sign (PWS) and ischial-spine-sign (ISS) are important radiographic signs of the condition. The pelvic area is sensitive to radiation and thus, possibilities to reduce dose should be considered. The purpose was to compare radiographic signs of acetabular retroversion on conventional pelvic anteroposterior (AP) X-rays with a low-dose slot-scanning system (EOS) in a sample of patients with retroversion of the acetabulum and to compare the radiation doses. Methods34 participants with radiographic signs of acetabular retroversion in one or both hips on conventional pelvic X-ray were consecutively recruited. Pelvic EOS-images were acquired in each patient and COS, PWS, ISS, COS-ratio and PWS-ratio was assessed. Radiation dose comparison of X-ray vs. EOS was performed using Dose-Area Products. ResultsRetroversion was present in 57 out of 68 hips. The absolute agreement was 91%, 84% and 76% for COS, PWS and ISS, respectively. No statistically significant differences were present between COS-ratio and PWS-ratio in either modality and Bland–Altman limits of agreement were narrow. The mean radiation dose was 1053 mGy*cm2 in X-ray and 593 mGy*cm2 in EOS (p = 0.003). ConclusionThe results indicate that pelvic EOS provides diagnostic qualities similar to conventional X-ray using 44% less radiation when radiographic signs of acetabular retroversion are assessed.

Occupational and patient exposure as well as image quality for full spine examinations with the EOS imaging system.

EOS (EOS imaging S.A, Paris, France) is an x-ray imaging system that uses slot-scanning technology in order to optimize the trade-off between image quality and dose. The goal of this study was to characterize the EOS system in terms of occupational exposure, organ doses to patients as well as image quality for full spine examinations. Occupational exposure was determined by measuring the ambient dose equivalents in the radiological room during a standard full spine examination. The patient dosimetry was performed using anthropomorphic phantoms representing an adolescent and a five-year-old child. The organ doses were measured with thermoluminescent detectors and then used to calculate effective doses. Patient exposure with EOS was then compared to dose levels reported for conventional radiological systems. Image quality was assessed in terms of spatial resolution and different noise contributions to evaluate the detector's performances of the system. The spatial-frequency signal transfer efficiency of the imaging system was quantified by the detective quantum efficiency (DQE). The use of a protective apron when the medical staff or parents have to stand near to the cubicle in the radiological room is recommended. The estimated effective dose to patients undergoing a full spine examination with the EOS system was 290 μSv for an adult and 200 μSv for a child. MTF and NPS are nonisotropic, with higher values in the scanning direction; they are in addition energy-dependent, but scanning speed independent. The system was shown to be quantum-limited, with a maximum DQE of 13%. The relevance of the DQE for slot-scanning system has been addressed. As a summary, the estimated effective dose was 290 μSv for an adult; the image quality remains comparable to conventional systems.

Benefits and unexpected artifacts of biplanar digital slot-scanning imaging in children

Biplanar digital slot-scanning allows for relatively low-dose orthopedic imaging, an advantage in imaging children given the growing concerns regarding radiosensitivity. We have used this system for approximately 1year for orthopedic imaging of the spine and lower extremities. We have noted advantages of using the digital slot-scanning system when compared with computed radiographic and standard digital radiographic imaging systems, but we also found unexpected but common imaging artifacts that are the direct result of the imaging method and that have not been reported. This pictorial essay serves to familiarize radiologists with the advantages of the digital slot-scanning system as well as imaging artifacts common with this new technology.

Evaluation of a new low-dose biplanar system to assess lower-limb alignment in 3D: a phantom study

Knee coronal alignment is routinely assessed on a full-length radiograph of the lower limbs. However, poor positioning of the knee during the procedure affects the accuracy of this kind of measurement, particularly in cases combining knee rotation and flexion. The purpose of this study was to assess the value of a three-dimensional assessment of the hip-knee-ankle (HKA) angle based on a biplanar radiographic system. A biplanar slot scanning system was used to take radiographs of three lower-limb synthetic models with similar frontal deviation (5° valgus) but different flexion angulations (0°, 9°, and 18°). Biplane acquisitions were done with lower-limb axial rotations ranging from 20° of internal rotation to 20° of external rotation on each of the lower limb models. Three independent observers performed standard 2D measurements of the HKA angle from each anteroposterior (AP) image and also modeled the lower limb in 3D for each biplane acquisition with dedicated software. The HKA angle was automatically calculated from the 3D models. The results of the 2D and 3D techniques were compared. Axial rotation provoked 2D HKA measurement errors up to, respectively, 1.4°, 4.7°, and 6.8° for the lower extremities with 0°, 9°, and 18° flexion, while it never affected the 3D HKA measurement for more than 1.5°. Interobserver errors were 0.7° (SD = 0.5°) for the 2D measurements and 0.6° (SD = 0.4°) for the 3D measurements. The 3D modeling allows for a more accurate evaluation of coronal alignment compared to 2D, eliminating bias due to wrong knee positioning.

TU‐C‐330D‐01: Advances in Breast Imaging

Despite development and advances of new modalities, x‐ray mammography remains the main screening tool for early detection of breast cancers. It also continues to play an important role in the diagnosis and management of breast cancers. X‐ray mammography has relied on the use of high resolution screen/film combinations. Such techniques, although improved over the years, have the drawbacks of all the inconveniences and inflexibility associated with the use of film for image acquisition, storage and display. Motivated by search for better image quality and a general move towards filmless radiology, various digital mammography techniques have been developed, investigated and commercialized. These techniques can be largely divided into four types: amorphous silicon and selenium flat panel detector, amorphous silicon and cesium iodide flat panel detector, CCD and cesium iodide based slot scanning system, and storage phosphor imaging technique with dual‐side image read out. Each of these systems has its unique advantages and disadvantages and achieves various degrees of clinical implementation. Typical of all digital mammography techniques is the potential compatibility with digital image archival, retrieval and distribution systems. Furthermore, the acquisition of breast images in digital format has begun to facilitate the development and investigation of many advanced imaging techniques. Among them, dual‐energy mammography techniques have been developed to quantify breast tissue composition or to separate calcifications from the overlying tissue structures. Stereo‐mammography has been developed to use two projection views to provide a 3‐D perspective of the breast tissue structures, thus reducing the problem of overlapping structures. Tomosynthesis imaging pushes the idea of 3‐D imaging further by acquiring 10–25 projection views and use them to synthesize images to depict the breast structures as a number of thick layers. More recently, cone beam breast CT has been developed and investigated to scan the breast in a dedicated manner and provide true 3‐D images of the breast. Along a different direction, the development and investigation of various contrast mammography techniques have allowed x‐ray imaging to be used to image and study breast vasculatures as possible indication of breast cancer.In this presentation, we will try to achieve the following educational objectives:1. Review the development and investigation of major digital mammography techniques.2. Review the development and investigation of various advanced breast x‐ray imaging techniques.Research sponsored by the National Cancer Institute and the National Institute of Biomedical Imaging and Bioengineering.

Effect of scatter and an antiscatter grid on the performance of a slot‐scanning digital mammography system

The use of a grid increases perceptibility of low contrast objects in mammography. Slot-scan mammography provides a more dose efficient reduction of the scattered radiation reaching the detector than obtained with an antiscatter grid in screen-film or flat-panel digital mammography. In this paper, the potential of using a grid in a slot-scan system to provide a further reduction of scattered radiation is investigated. The components of the digital signal: primary radiation, off-focus radiation, scattered radiation, and optical fluorescence glare in a CsI(Tl) detector were quantified. Based on these measurements, the primary and scatter transmission factors (Tp, Ts), scatter-to-primary ratio (SPR), signal-difference-to-noise ratio (SDNR), and the SDNR improvement factor (K(SDNR)) were obtained. Our results showed that the SPR ranged from 0.05 to 0.19 for breast thicknesses between 2 and 8 cm, respectively. The values of K(SDNR) ranged from 0.85 to 0.94. Because the slot-scanning system has an inherently low SPR, the increase in dose required when the grid is used outweighs the benefit of the small increase in SDNR. It is possible that greater benefit could be achieved by using a grid with a higher Tp, such as obtained using air-core technology.

Comparative Scatter and Dose Performance of Slot-Scan and Full-Field Digital Chest Radiography Systems

To evaluate the scatter, dose, and effective detective quantum efficiency (DQE) performance of a slot-scan digital chest radiography system compared with that of a full-field digital radiography system. Scatter fraction of a slot-scan system was measured for an anthropomorphic and a geometric phantom by using a posterior beam-stop technique at 117 and 140 kVp. Measurements were repeated with a full-field digital radiography system with and without a 13:1 antiscatter grid at 120 and 140 kVp. For both systems, the effective dose was measured on posteroanterior and lateral views for standard clinical techniques by using dosimeters embedded in a female phantom. The effective DQEs of the two systems were assessed by taking into account the scatter performance and the DQE of each system. The statistical significance of all the comparative differences was ascertained by means of t test analysis. The slot-scan system and the full-field system with grid yielded scatter fractions of 0.13-0.14 and 0.42-0.48 in the lungs and 0.30-0.43 and 0.69-0.78 in the mediastinum, respectively. The sum of the effective doses for posteroanterior and lateral views for the slot-scan system (0.057 mSv +/- 0.003 [+/- standard deviation]) was 34% lower than that for the full-field system (0.086 mSv +/- 0.001, P < .05) at their respective clinical peak voltages (140 and 120 kVp, respectively). The effective DQE of the slot-scan system was equivalent to that of the full-field system in the lung region but was 37% higher in the dense regions (P < .05). The slot-scan design leads to marked scatter reduction compared with the more conventional full-field geometries with a grid. The improved scatter performance of a slot-scan geometry can effectively compensate for low DQE and lead to improved image quality.