Single-cell Force Microscopy Research Articles

A New Function for Amyloid-Like Interactions: Cross-Beta Aggregates of Adhesins form Cell-to-Cell Bonds.

Amyloid structures assemble through a repeating type of bonding called “cross-β”, in which identical sequences in many protein molecules form β-sheets that interdigitate through side chain interactions. We review the structural characteristics of such bonds. Single cell force microscopy (SCFM) shows that yeast expressing Als5 adhesin from Candida albicans demonstrate the empirical characteristics of cross-β interactions. These properties include affinity for amyloid-binding dyes, birefringence, critical concentration dependence, repeating structure, and inhibition by anti-amyloid agents. We present a model for how cross-β bonds form in trans between two adhering cells. These characteristics also apply to other fungal adhesins, so the mechanism appears to be an example of a new type of cell–cell adhesion.

Surface Coatings Modulate the Differences in the Adhesion Forces of Eukaryotic and Prokaryotic Cells as Detected by Single Cell Force Microscopy.

Single cell force microscopy was used to investigate the maximum detachment force (MDF) of primary neuronal mouse cells (PNCs), osteoblastic cells (MC3T3), and prokaryotic cells (Staphylococcus capitis subsp. capitis) from different surfaces after contact times of 1 to 5 seconds. Positively charged silicon nitride surfaces were coated with positively charged polyethyleneimine (PEI) or poly-D-lysine. Laminin was used as the second coating. PEI induced MDFs of the order of 5 to 20 nN, slightly higher than silicon nitride did. Lower MDFs (1 to 5 nN) were detected on PEI/laminin with the lowest on PDL/laminin. To abstract from the individual cell properties, such as size, and to obtain cell type-specific MDFs, the MDFs of each cell on the different coatings were normalized to the silicon nitride reference for the longest contact time. The differences in MDF between prokaryotic and eukaryotic cells were generally of similar dimensions, except on PDL/laminin, which discriminated against the prokaryotic cells. We explain the lower MDFs on laminin by the spatial prevention of the electrostatic cell adhesion to the underlying polymers. However, PEI can form long flexible loops protruding from the surface-bound layer that may span the laminin layer and easily bind to cellular surfaces and the small prokaryotic cells. This was reflected in increased MDFs after two-second contact times on silicon nitride, whereas the two-second values were already observed after one second on PEI or PEI/laminin. We assume that the electrostatic charge interaction with the PEI loops is more important for the initial adhesion of the smaller prokaryotic cells than for eukaryotic cells.

A Structural Change in Butyrophilin upon Phosphoantigen Binding Underlies Phosphoantigen-Mediated Vγ9Vδ2 T Cell Activation

Human Vγ9Vδ2 Tcells respond to microbial infections and malignancy by sensing diphosphate-containing metabolites called phosphoantigens, which bind to the intracellular domain of butyrophilin 3A1, triggering extracellular interactions with the Vγ9Vδ2 Tcell receptor (TCR). Here, we examined the molecular basis of this "inside-out" triggering mechanism. Crystal structures of intracellular butyrophilin 3A proteins alone or in complex with the potent microbial phosphoantigen HMBPP or a synthetic analog revealed key features of phosphoantigens and butyrophilins required for γδ Tcell activation. Analyses with chemical probes and molecular dynamic simulations demonstrated that dimerized intracellular proteins cooperate in sensing HMBPP to enhance the efficiency of γδ Tcell activation. HMBPP binding to butyrophilin doubled the binding force between a γδ Tcell and a target cell during "outside" signaling, as measured by single-cell force microscopy. Our findings provide insight into the "inside-out" triggering of Vγ9Vδ2 Tcell activation by phosphoantigen-bound butyrophilin, facilitating immunotherapeutic drug design.

Enhancing the regeneration of bone defects by alkalizing the peri-implant zone – anin vitroapproach

AbstractThe effects of alkaline pH on the initial adhesion of osteoblasts to titanium surfaces was analyzed by single cell force microscopy (SCFM). In the SCFM measurements, the same cells were used to compare their unspecific adhesion to uncoated titanium with their specific adhesion to collagen coated titanium. When the maximum detachment forces (MDFs) were compared at pH 7.4 and 8.0, only slight differences were found on pure titanium, while the MDFs were significantly increased at collagen coated surfaces at pH 8.0. Effects on the subsequent proliferation and gene expression were investigated in anin vitromodel system consisting of an alkalizing polyvinyl alcohol (PVA) matrix and a perforated titanium disc. The sodium hydroxide releasing matrix maintained the medium pH between pH 7.6 and pH 8.4 during the entire experiment. Under these conditions, cell counts were significantly increased with respect to the control system after 7 days in culture. These results were supported by gene expression analyses, which showed an upregulation of proliferation-controlling genes of the EGFR1 and PI3K/AKT pathways after 14 days in culture. The SCFM data were complemented by findings of an intensive regulation of genes known to be associated with focal adhesion such as Itga8 and Tnn.

Impacts of pH-mediated EPS structure on probiotic bacterial pili–whey proteins interactions

Probiotic bacteria are routinely incorporated into dairy foods because of the health benefits they can provide when consumed. In this work, the marked pH-dependence of the pili/EPS organization at the outer surface of Lactobacillus rhamnosus GG is characterized in detail by Single Cell Force Microscopy and cell electrophoretic mobility measurements analyzed according to formalisms for nanomechanical contact and soft particle electrokinetics, respectively. At pH 6.8, LGG pili are easily accessible by AFM tips functionalized with whey proteins for specific binding, while at pH 4.8 the collapsed EPS surface layer significantly immobilized the LGG pili. This resulted in their reduced accessibility to the specific whey-coated AFM tip, and to stronger whey protein–pili rupture forces. Thus, pili interactions with whey proteins are screened to an extent that depends on the pH-mediated embedment of the pili within the EPS layer.

Cooperativity in Adhesion Cluster Formation during Initial Cell Adhesion

We have studied the initial phase of cell adhesion as a function of the lateral organization of individual integrin molecules with single-cell force microscopy. Nanostructures, consisting of hexagonally ordered gold dots, were prepared with diblock-copolymer micelle lithography and functionalized with arginine- glycine-aspartate peptides, thus defining integrin position with nanometer resolution. Adhesion strength was characterized with an atomic force microscope and both cell detachment forces and work of detachment showed a reinforcement of adhesion if the distance between integrin molecules was <70 nm. This reinforcement had already occurred at cell-substrate contact times <5 min. We believe our results show quantitatively the relevance of the distance between adjacent integrin binding sites rather than their density. Furthermore, we propose a model describing the cooperative stabilization of early integrin clusters as a function of receptor patterning at the nanoscale.