Simulation Of Mechanical Processes Research Articles

Calculating permissible deviations of vibration accelerations of printed circuit assemblies by simulation modeling

Objectives. A variety of technical condition control methods are used in the production and operation of printed circuit assemblies (PCA) for radio-electronic means (REM). The main methods are optical, electrical, and thermal. However, not all possible defects can be detected using these methods. For example, a weakened PCA fastener in a block or the incorrect installation of an electric radioelement (ERE) on a printed circuit board (PCB) can be detected only by analyzing the mechanical characteristics of the REM. These factors, in particular, are the values of the vibration acceleration amplitudes on ERE or at selected PCB control points (hereinafter referred to as the PCA vibration acceleration amplitude). In order to draw a conclusion about the presence of a defect, the measured values of the vibration acceleration amplitudes obtained as a result of testing PCA for the effects of harmonic vibration are compared with the permissible values calculated during the simulation of mechanical processes in PCA. This takes into account the variations in the physical and mechanical parameters of materials and geometric parameters of the PCA design. The aim of this paper is to determine the permissible values of PCA vibration acceleration amplitudes to be compared with the measured values.Methods. The Monte Carlo simulation method is used to calculate the permissible deviations of vibration accelerations. This consists in repeatedly calculating the values of the vibration acceleration amplitudes at random values of the physical and mechanical parameters of materials and geometric parameters of the PCA design within their tolerances.Results. Experimental verification of this method was carried out using the SolidWorks software for modeling mechanical processes. This enabled the tolerance values for PCA vibration acceleration at the control point at the first resonant frequency to be established and experimental data to be obtained when introducing various defects. The results of comparing the measured values with the calculated tolerance enabled conclusions to be made with regard to the possibility of detecting PCA defects.Conclusions. Using this method of calculating tolerances for the PCA vibration acceleration amplitude allows the presence of defects in REM that do not affect the electrical or thermal characteristics of REM to be determined, thus increasing the efficiency of technical condition control.

Simulation of Mechanical Processes at the Contact Region of a Dental Implant with Bone Tissues Under Shock Wave Treatment

Dental implants are becoming an increasingly important part of modern dental treatment. Developing an optimal implant surface design can improve osseointegration. Promising to increase the rate of osseointegration is the use of external shock wave therapy, which has proven itself for the treatment of fractures, bone defects, and bone tissue regeneration during surgery and arthroplasty. This work aims at a numerical investigation of the effects of low-energy shock wave therapy of various ranges on the mechanical behaviour of bone tissues, taking into account the physiological characteristics in the area of dental implant placement. Modelling was carried out using the method of movable cellular automata. Using computer simulation, it was found that the conditions for the regeneration of bone tissues at the near-contact zone with the implant of the jaw segment are created by a shock wave with an intensity of greater than 0.1 mJ/mm2.

Numerical simulation of dynamic processes in biomechanics using the grid-characteristic method

Results of the numerical simulation of mechanical processes occurring in biological tissues under dynamic actions are presented. The grid-characteristic method on unstructured grids is used to solve the system of equations of mechanics of deformable solids; this method takes into account the characteristic properties of the constitutive system of partial differential equations and produces adequate algorithms on interfaces between media and on the boundaries of integration domains.

Numerical analysis of the loosened total hip replacements (THR)

The paper deals with mathematical simulation of a loosened hip joint, simulation of mechanical processes taking place during static and dynamic burdening and their mathematical description. The main result of the paper consists of the existence theorem and the analysis of the loosened total hip replacement (THR).