Simple Solid-phase Microextraction Research Articles

A novel 3D-printed solid phase microextraction device equipped with silver-polyaniline coated pencil lead for the extraction of phthalate esters in cosmeceutical products

A screw-based portable and simple solid phase microextraction device was fabricated by a 3D printer and used in combination with the developed silver-incorporated porous polyaniline film pencil lead solid-phase microextraction fiber (Ag/PANI SPME). Scanning electron microscopy revealed a porous structure of the electrodeposited Ag/PANI film. The spectrum from energy dispersive x-ray spectroscopy (EDS) and the elemental map confirmed the presence of silver in the porous polymer film. It was used under stirring for the extraction of five phthalate esters: dimethyl phthalate (DMP), diethyl phthalate (DEP), dibutyl phthalate (DBP), benzyl butyl phthalate (BBP) and di-2-ethylhexyl phthalate (DEHP). The extracted solution was identified and quantified by gas chromatography using a flame ionization detector (GC-FID). Under the optimum conditions of the developed method, a good linearity was obtained in a concentration range of 5.0–1000 μg L−1 for all five phthalate esters with limits of detection (LODs) of 4.41 ± 0.91 μg L−1, 3.98 ± 0.92 μg L−1, 3.65 ± 0.74 μg L−1, 4.91 ± 0.52 μg L−1 and 4.25 ± 0.66 μg L−1 for DMP, DEP, DBP, BBP and DEHP, respectively. The developed method provided good precision when tested with standard solutions (RSD < 5.5%, n = 6) and real samples (RSD < 3.4%, n = 6). Good fiber-to-fiber reproducibility was also confirmed by extraction with six newly prepared fibers; recoveries ranged from 81.09 ± 0.54% to 92.92 ± 0.46% with RSD <6.6%. The developed method was used to determine phthalate esters in 14 cosmeceutical samples. In rubbing alcohol samples, DEP and DEHP were detected at 7.03 ± 0.76 μg L−1 and 5.89 ± 0.53 μg L−1, respectively, while in contact lens cleaners, DEHP was found in a concentration range from 5.3 ± 1.1 μg L−1 to 6.8 ± 1.2 μg L−1. No phthalate esters contamination was detectable in saline solutions, eye cleaners and antibacterial disinfectant liquids. Recoveries in the range of 81.92 ± 0.99% to 102.4 ± 1.1% indicated the good accuracy of the developed method.

Solid phase microextraction of diclofenac using molecularly imprinted polymer sorbent in hollow fiber combined with fiber optic-linear array spectrophotometry

A simple solid phase microextraction method based on molecularly imprinted polymer sorbent in the hollow fiber (MIP-HF-SPME) combined with fiber optic-linear array spectrophotometer has been applied for the extraction and determination of diclofenac in environmental and biological samples. The effects of different parameters such as pH, times of extraction, type and volume of the organic solvent, stirring rate and donor phase volume on the extraction efficiency of the diclofenac were investigated and optimized. Under the optimal conditions, the calibration graph was linear (r2=0.998) in the range of 3.0–85.0μgL−1 with a detection limit of 0.7μgL−1 for preconcentration of 25.0mL of the sample and the relative standard deviation (n=6) less than 5%. This method was applied successfully for the extraction and determination of diclofenac in different matrices (water, urine and plasma) and accuracy was examined through the recovery experiments.

A fast and simple solid phase microextraction coupled with gas chromatography-triple quadrupole mass spectrometry method for the assay of urinary markers of glutaric acidemias

The analysis of characteristic urinary acidic markers such as glutaric, 3-hydroxyglutaric, 2-hydroxyglutaric, adipic, suberic, sebacic, ethylmalonic, 3-hydroxyisovaleric and isobutyric acid constitutes the recommended follow-up testing procedure for glutaric acidemia type 1 (GA-1) and type 2 (GA-2). The goal of the work herein presented is the development of a fast and simple method for the quantification of these biomarkers in human urine. The proposed analytical approach is based on the use of solid phase microextraction (SPME) combined with gas chromatography-triple quadrupole mass spectrometry (GC-QqQ-MS) afterward a rapid derivatization of acidic moieties by propyl chloroformate, propanol and pyridine. Trueness and precision of the proposed protocol, tested at 5, 30 and 80mgl−1, provided satisfactory values: recoveries were in the range between 72% and 116% and the relative standard deviations (RSD%) were between 0.9% and 18% (except for isobutyric acid at 5mgl−1). The LOD values achieved by the proposed method ranged between 1.0 and 473μgl−1.

Optimization of solid phase microextraction coatings for liquid chromatography mass spectrometry determination of neurotransmitters

A simple solid phase microextraction method coupled to liquid chromatography mass spectrometry is introduced for the analysis of neurotransmitter compounds with a wide range of polarities in biological matrices. A novel “reversed” reverse-phase chromatographic method was developed without pre-column derivatization for the analysis of dopamine, serotonin, gamma aminobutyric acid and glutamate. New solid phase microextraction “in house” coatings using mixed-mode solid phase extraction particles were prepared, and used for the extraction of polar neurotransmitters. The polymer-support base reverse phase mixed-mode sorbents with strong ion exchange properties generally had higher extraction efficiencies compared to similar sorbents with weak ion exchange properties. The linear range was determined to be between 0.01 and 150ng/mL for all the analytes, except for GABA, which was from 0.1 to 100ng/mL. The limit of detection range was from 6 to 10pg/mL for all the neurotransmitters, and the limits of quantitation were in the range of 20–35pg/mL. The results demonstrate the potential of the SPME-LC–MS/MS technique for bioanalysis of small polar endogenous compounds, such as neurotransmitters, from various biological matrices using the mixed-mode sorbents as the extraction phase.

Effects of Soybean Pectin Gel on Flavor Compounds Variation of Cheddar Cheeses during Ripening

In this manuscript, flavor compounds development of Cheddar Cheese with addition of soybean pectin gel was investigated during ripening. A rapid and simple Solid-Phase Microextraction (SPME) procedure was used for identifying and classifying the volatile compounds. The result showed that addition of soybean pectin gel to cheese had similar flavor profiles with full-fat cheeses. Higher levels of acid volatile compounds and aldehydes were obtained in comparison with experimental cheese. Results simultaneously indicated that experimental cheeses contained high concentrations of volatile amine as soybean pectin gel promoting the volatile substances.

Quantitative solid phase microextraction – Gas chromatography mass spectrometry analysis of the pesticides lindane, heptachlor and two heptachlor transformation products in groundwater

This paper describes the development and validation of a method for the determination of lindane, heptachlor and two heptachlor transformation products (exo- and endo-heptachlor epoxide) in groundwater. Samples were extracted using a simple solid phase microextraction (SPME) method with a polyacrylate fibre prior to detection by gas chromatography mass spectrometry in electron impact ionisation mode (GC–EI-MS). The linearity of the method ranged from 0.015 to 5.0μgL−1, with correlation coefficients greater than 0.99. Recoveries ranged from 96 to 101% at several fortification levels with all coefficients of variation (CV%) less than 10.5%. The method was validated to the permitted limits laid down in the European Union drinking water directive (98/83/EC). The limit of quantitation (LOQ) was 0.015μgL−1 in groundwater samples. Samples had to be analysed within 24h of collection otherwise degradation occurred and disposable SPME polyacrylate fibres lasted up to 51 injections. Both endo-heptachlor epoxide and lindane were detected in groundwater samples with concentrations ranging between 0.033 and 0.048μgL−1.

Source and deposition of polycyclic aromatic hydrocarbons to Shanghai, China

Abstract Despite recent efforts to investigate the distribution and fate of polycyclic aromatic hydrocarbons (PAHs) in air, water, and soil, very little is known about their temporal change in wet deposition. As a result of increased attention to public health, a large-scale survey on the deposition flux and distribution of PAH contamination in rainwater was urgently conducted in Shanghai, China. In this study, 163 rainwater samples were collected from six sites, and 15 PAH compounds were detected by the use of a simple solid phase microextraction (SPME) technique coupled with gas chromatography-mass spectrometry. The dominant PAH species monitored were naphthalene, phenanthrene, anthracene, and fluoranthene. The concentration of total PAHs per event was between 74 and 980 ng/L, with an average value of 481 ng/L, which is at the high end of worldwide figures. The annual deposition flux of PAHs in rainwater was estimated to be 4148 kg/yr in the Shanghai area, suggesting rainfall as a major possible pathway for removing PAHs from the atmosphere. Diagnostic analysis by the ratios of An/178 and Fl/Fl+Py suggested that combustion of grass, wood, and coal was the major contributor to PAHs in the Shanghai region. Back trajectory analysis also indicated that the pollutant sources could be from the southern part of China.

Rapid Screening of Anabolic Steroids in Urine by Reactive Desorption Electrospray Ionization

Fast screening for anabolic steroids in whole urine is achieved by combining reactive desorption electrospray ionization (reactive DESI) and tandem mass spectrometry. Spray solutions containing hydroxylamine allow heterogeneous reactions of hydroxylamine with the carbonyl group of the steroids during the ionization process. Seven steroids, including a glycosteroid, were examined. The ion/molecule reaction adduct and the oxime formed via its dehydration were observed using reactive DESI; the protonated and sodiated forms of the ionized steroid were also observed both in reactive DESI and in DESI performed without the added hydroxylamine reagent. Paper, glass, and polytetrafluoroethylene were tested as sample substrates, but the glycosteroid was ionized intact without hydrolysis only from polytetrafluoroethylene. Limits of detection for the pure compounds were less than 1 ng, dynamic ranges were typically 2 orders of magnitude, and analysis times were just a few seconds. Concentration levels of ketosteroids in raw urine relevant to screening for sports doping (approximately 20 ng/mL) can be reached using a simple solid-phase microextraction (SPME) preconcentration step. Reactive DESI provided significant improvements in ionization efficiency of these steroids in raw undiluted urine as compared to conventional DESI; suppression effects due to the sample matrix were minimal and the urine matrix had no deleterious effect on steroid detection limits. Tandem mass spectrometry provided confirmation of analyte identification in this rapid screening process.

Analysis of chloro- and nitrobenzenes in water by a simple polyaniline-based solid-phase microextraction coupled with gas chromatography

A simple solid-phase microextraction (SPME) device, coupled with gas chromatography–electron capture detection (GC–ECD) was developed to detect trace levels of chloro- and nitrobenzene compounds in environmental water samples. Polyaniline (PANI) was chosen as the extraction material for the SPME device, and was electrochemically deposited on a stainless steel wire to achieve high mechanical stability. Due to the peculiar π − π conjugated structure, PANI coating shows a stable performance in high temperature (to 350 °C) and solvents (organic and inorganic). The porous structure of PANI film characterized by scanning electron microscopy (SEM) revealed high extraction efficiency. The possible extraction mechanism was explained by the study carried out using electrochemical impedance spectroscopy (EIS). Eight chloro- and nitrobenzene compounds were selected to evaluate the SPME–GC procedures. The key parameters such as extraction and desorption temperature and time, and the ionic strength were investigated and optimized. The method was applied to the detection of environmental water samples collected from Taihu Lake, representing nowadays contamination level under industrial impact. The whole PANI-SPME–GC method offers high accuracy and precision, high sensitivity and low detection limits. Thus, the method developed could be used as a new way to monitor the trace levels of chloro- and nitrobenzene compounds in real water bodies.

Determination of phthalates in water samples using polyaniline-based solid-phase microextraction coupled with gas chromatography

A simple solid-phase microextraction (SPME) device, coupled with gas chromatography-flame ionization detection (GC-FID), was developed to detect trace levels of phthalates in environmental water samples. Polyaniline (PANI) was chosen as the sorbent for the SPME device and was electrochemically deposited on a stainless steel wire to achieve high thermal and mechanical stability. The porous structure of the PANI film, characterized by scanning electron microscopy (SEM), suggested large extraction capability. Key parameters were optimized and five phthalates were selected to evaluate the SPME-GC procedures. The method was also applied to the analysis of lake and river water samples. Control experiments were carried out using commercial polyacrylate (PA) fiber. The new PANI-SPME-GC method offers high accuracy, precision and sensitivity and low detection limits. Thus, the method developed could be used as a new way to monitor the trace levels of phthalates in water medium. A possible extraction mechanism was investigated using electrochemical impedance spectroscopy (EIS).