SESAM-modelocked Thin-disk Laser Research Articles

Peak-power scaling of femtosecond Yb:Lu2O3 thin-disk lasers.

We present a high-peak-power SESAM-modelocked thin-disk laser (TDL) based on the gain material Yb-doped lutetia (Yb:Lu2O3), which exceeds a peak-power of 10 MW for the first time. We generate pulses as short as 534 fs with an average power of 90 W and a peak power of 10.1 MW, and in addition a peak power as high as 12.3 MW with 616-fs pulses and 82-W average power. The center lasing wavelength is 1033 nm and the pulse repetition rates are around 10 MHz. We discuss and explain the current limitations with numerical models, which show that the current peak power is limited in soliton modelocking by the interplay of the gain bandwidth and the induced absorption in the SESAM with subsequent thermal lensing effects. We use our numerical model which is validated by the current experimental results to discuss a possible road map to scale the peak power into the 100-MW regime and at the same time reduce the pulse duration further to sub-200 fs. We consider Yb:Lu2O3 as currently the most promising gain material for the combination of high peak power and short pulse duration in the thin-disk-laser geometry.

Frequency comb offset dynamics of SESAM modelocked thin disk lasers.

We present a detailed study of the carrier-envelope offset (CEO) frequency dynamics of SESAM modelocked thin disk lasers (TDLs) pumped by kW-class highly transverse multimode pump diodes with a typical M(2) value of 200-300, and give guidelines for future frequency stabilization of multi-100-W oscillators. We demonstrate CEO frequency detection with > 30 dB signal-to-noise ratio with a resolution bandwidth of 100 kHz from a SESAM modelocked Yb:YAG TDL delivering 140 W average output power with 748-fs pulses at 7-MHz pulse repetition rate. We compare with a low-power CEO frequency stabilized Yb:CALGO TDL delivering 2.1 W with 77-fs pulses at 65 MHz. For both lasers, we perform a complete noise characterization, measure the relevant transfer functions (TFs) and compare them to theoretical models. The measured TFs are used to determine the propagation of the pump noise step-by-step through the system components. From the noise propagation analysis, we identify the relative intensity noise (RIN) of the pump diode as the main contribution to the CEO frequency noise. The resulting noise levels are not excessive and do not prevent CEO frequency stabilization. More importantly, the laser cavity dynamics are shown to play an essential role in the CEO frequency dynamics. The cavity TFs of the two lasers are very different which explains why at this point a tight CEO frequency lock can be obtained with the Yb:CALGO TDL but not with the Yb:YAG TDL. For CEO stabilization laser cavities should exhibit high damping of the relaxation oscillations by nonlinear intra-cavity elements, for example by operating a SESAM in the roll-over regime. Therefore the optimum SESAM operation point is a trade-off between enough damping and avoiding multiple pulsing instabilities. Additional cavity components could be considered for supplementary damping independent of the SESAM operation point.

Toward Millijoule-Level High-Power Ultrafast Thin-Disk Oscillators

SESAM modelocked thin-disk lasers have recently reached new frontiers and remain the leading technology in terms of average power and pulse energy, setting new performance levels for ultrafast oscillators. The milestones achieved seem to indicate that there are no major roadblocks ahead to achieve further scaling of modelocked oscillators to kilowatt output powers and millijoule output pulse energies. In this paper, we review the current state of the art and present the next steps toward future generations of millijoule, kilowatt-class ultrafast thin-disk oscillators.

Efficient spectral broadening in the 100-W average power regime using gas-filled kagome HC-PCF and pulse compression.

We present nonlinear pulse compression of a high-power SESAM-modelocked thin-disk laser (TDL) using an Ar-filled hypocycloid-core kagome hollow-core photonic crystal fiber (HC-PCF). The output of the modelocked Yb:YAG TDL with 127W average power, a pulse repetition rate of 7MHz, and a pulse duration of 740fs was spectrally broadened 16-fold while propagating in a kagome HC-PCF containing 13bar of static argon gas. Subsequent compression tests performed using 8.4% of the full available power resulted in a pulse duration as short as 88fs using the spectrally broadened output from the fiber. Compressing the full transmitted power through the fiber (118W) could lead to a compressed output of >100 W of average power and >100 MW of peak power with an average power compression efficiency of 88%. This simple laser system with only one ultrafast laser oscillator and a simple single-pass fiber pulse compressor, generating both high peak power >100 MW and sub-100-fs pulses at megahertz repetition rate, is very interesting for many applications such as high harmonic generation and attosecond science with improved signal-to-noise performance.

Dual-gain SESAM modelocked thin disk laser based on Yb:Lu₂O₃ and Yb:Sc₂O₃.

We present for the first time a SESAM-modelocked thin-disk laser (TDL) that incorporates two gain materials with different emission spectra in a single TDL resonator. The two gain media used in this experiment are the sesquioxide materials Yb:Lu2O3 and Yb:Sc2O3, which have their spectral emission peak displaced by ≈7 nm. We can benefit from a combined gain bandwidth that is wider than the one provided by a single gain material alone and still conserve the excellent thermal properties of each disk. In these first proof-of-principle experiments we demonstrate pulse durations shorter than previously achieved with the single gain material Yb:Lu2O3. The oscillator generates pulses as short as 103 fs at a repetition rate of 41.7 MHz and a center wavelength of around 1038 nm, with an average output power of 1.4 W. A different cavity layout provides pulses with a duration of 124 fs at an output power of 8.6 W. This dual-gain approach should allow for further power scaling of TDLs and these first results prove this method to be a promising new way to combine the record output-power performance of modelocked TDLs with short pulse durations in the sub-100 fs regime.

Phase-stabilization of the carrier-envelope-offset frequency of a SESAM modelocked thin disk laser

We phase-stabilized the carrier-envelope-offset (CEO) frequency of a SESAM modelocked Yb:CaGdAlO₄ (CALGO) thin disk laser (TDL) generating 90-fs pulses at a center wavelength of 1051.6 nm and a repetition rate of 65 MHz. By launching only 2% of its output power into a photonic crystal fiber, we generated a coherent octave-spanning supercontinuum spectrum. Using a standard f-to-2f interferometer for CEO detection, we measured CEO beats with 33 dB signal-to-noise ratio in 100 kHz resolution bandwidth. We achieved a tight lock of the CEO frequency at 26.18 MHz by active feedback to the pump current. The residual in-loop integrated phase noise is 120 mrad (1 Hz-1 MHz). This is, to our knowledge, the first CEO-stabilized SESAM modelocked TDL. Our results show that a reliable lock of the CEO frequency can be achieved using standard techniques in spite of the strongly spatially multimode pumping scheme of TDLs. This opens the door towards fully-stabilized low-noise frequency combs with hundreds of watts of average power from table-top SESAM modelocked thin disk oscillators.

Yb-doped mixed sesquioxides for ultrashort pulse generation in the thin disk laser setup

We report on spectroscopic investigations of the mixed sesquioxide laser materials Yb:LuScO3, Yb:YScO3, and Yb:(Lu,Y,Sc)2O3 as well as mode-locked thin disk laser experiments with Yb:LuScO3 and Yb:(Lu,Y,Sc)2O3. The disordered crystal structures of these materials result in significantly broader emission spectra than for the pure sesquioxides Yb:Sc2O3, Yb:Y2O3, and Yb:Lu2O3 providing a high potential for ultrashort pulse generation. In SESAM mode-locked thin disk laser experiments, pulse durations of around 100 fs could be obtained exploiting >70 % of the gain bandwidth which is to the best of our knowledge the optimum obtained so far for the mode-locked lasers in this setup.

Temporal pulse compression in a xenon-filled Kagome-type hollow-core photonic crystal fiber at high average power

In this study we demonstrate the suitability of Hollow-Core Photonic Crystal Fibers (HC-PCF) for multiwatt average power pulse compression. We spectrally broadened picosecond pulses from a SESAM mode-locked thin disk laser in a xenon gas filled Kagome-type HC-PCF and compressed these pulses to below 250 fs with a hypocycloid-core fiber and 470 fs with a single cell core defect fiber. The compressed average output power of 7.2 W and 10.2 W at a pulse repetition rate of approximately 10 MHz corresponds to pulse energies of 0.7 µJ and 1 µJ and to peak powers of 1.6 MW and 1.7 MW, respectively. Further optimization of the fiber parameters should enable pulse compression to below 50 fs duration at substantially higher pulse energies.

Pulse compression of a high-power thin disk laser using rod-type fiber amplifiers

We report on two pulse compressors for a high-power thin disk laser oscillator using rod-type fiber amplifiers. Both systems are seeded by a standard SESAM modelocked thin disk laser that delivers 16 W of average power at a repetition rate of 10.6 MHz with a pulse energy of 1.5 μJ and a pulse duration of 1 ps. We discuss two results with different fiber parameters with different trade-offs in pulse duration, average power, damage and complexity. The first amplifier setup consists of a Yb-doped fiber amplifier with a 2200 μm2 core area and a length of 55 cm, resulting in a compressed average power of 55 W with 98-fs pulses at a repetition rate of 10.6 MHz. The second system uses a shorter 36-cm fiber with a larger core area of 4500 μm2. In a stretcher-free configuration we obtained 34 W of compressed average power and 65-fs pulses. In both cases peak powers of > 30 MW were demonstrated at several μJ pulse energies. The power scaling limitations due to damage and self-focusing are discussed.