Total Particulate Matter Samples Research Articles

Monitoring and Risk Assessment of Polycyclic Aromatic Hydrocarbons in Mainstream Cigarette Smoke

Objectives : Cigarette smoking is an important factor in human exposure to polycyclic aromatic hydrocarbons (PAHs). Machine-smoking methods have been devised to evaluate inhalation exposure to mainstream cigarette smoke. However, there have been only a few studies that have employed these methods for PAH monitoring in Korea.Methods : Total particulate matter samples were collected from the mainstream smoke of five different cigarette types using the ISO 3308 standard smoking method. The samples were analyzed for 16 PAHs using a gas chromatograph/mass spectrometer (GC/MS) following extraction and clean-up procedures.Results and Discussion : The 16 PAH levels of cigarette samples ranged from 87.1 ng/cig to 247.4 ng/cig with an average of 135.4 ng/cig. The average fractions of PAHs classified by the number of rings were as follows: 15% (2 rings), 37% (3 rings), 43% (4 rings), 4% (5 rings), and 1% (6 rings). Diagnostic ratios suggested that the characteristics of PAH pollution in mainstream cigarette smoke were similar to those of biomass burning but different from those of ambient air. The carcinogenic risks of PAHs exceeded the risk threshold of the US EPA (1.0E-06) for the 10%, 30%, and 20% exposure groups of adult males, adult females, and all adults, respectively.Conclusion : This study highlights the significance of mainstream cigarette smoke in examining human inhalation exposure to PAHs and carcinogenic risks, which are primarily influenced by cigarette smoking rather than ambient air. These findings can contribute to a comprehensive assessment of inhalation exposure to PAHs and provide guidance for the development of environmental health policies aimed at reducing such exposure.

Lung cell toxicity of co-exposure to airborne particulate matter and extremely low-frequency magnetic field

Although the toxic effects of urban airborne particulate matter (PM) have been known on lung cells, there is less attention to co-exposure to PM and extremely low frequency magnetic (ELF-MF) in occupational settings. The present study investigated the influences of PM and ELF-MF co-exposure on toxicity in human lung cells (A549). In this case, total PM (TPM) was evaluated according to NIOSH-0500. The TPM SiO2 and metal contents were determined based on NIOSH-7602 and 7302, respectively. Besides, 900 mG ELF-MF exposure was simulated based on field measurements. The toxicity mechanisms were assessed by examining malondialdehyde, glutathione ratio, gene expression, and DNA strand breaks. Also, the toxicity indicators of the TPM samples were MDA generation, glutathione depletion, and DNA damage, and their impacts were analysed at doses below the LD50 (4 µg). In addition, gene expression of OGG1 and MTH1 was upregulated after TPM exposure at the lowest dose (2 µg). But ITPA was upregulated in the presence of ELF-MF. The co-exposure to TPM and ELF-MF decreased oxidative stress and DNA damage levels compared to a single exposure to TPM. Although the ELF-MF reduced toxicity in response to TPM, this reduction was not lower than the unexposed cells.

Respirator use and its impact on particulate matter exposure in aluminum manufacturing facilities.

Objectives As part of a large epidemiologic study of particulate health effect, this study aimed to report respirator use among total particulate matter (TPM) samples collected in a major aluminum manufacturing company from 1966‒2013 and evaluate the impact of respirator-use adjustment on exposure estimation. Methods Descriptive analyses were performed to evaluate respirator use across facilities and by facility type and job. Protection factors were applied to TPM measurements for recorded respirator use. Estimated TPM exposure for each job ‒ before and after respirator-use adjustment ‒ were compared to assess the impact of adjustment on exposure estimation. Results Respirator use was noted for 37% of 12 402 full-shift personal TPM samples. Measured TPM concentration ranged from less than detectable to 8220 mg/m3, with arithmetic mean, median and standard deviation being 10.6, 0.87 and 130 mg/m 3, respectively. Respirators were used more often in smelting facilities (52% of TPM measurements) than in fabricating (17%) or refinery facilities (28%) (P<0.01). Sixty-two percent of jobs in smelting facilities were subject to respirator-use adjustment, whereas it was 20% and 70% in fabricating and refinery facilities, respectively. Applying protection factors to TPM measurements significantly reduced estimated job mean TPM exposures and changed exposure categories in these facilities, with larger impact in smelting than fabricating facilities. Conclusions Respirator use varied by time, facility and job. Adjusting respirator use resulted in differential impact in smelting and fabricating facilities, which will need to be incorporated into ongoing epidemiologic studies accordingly.

Mutagenicity profile of atmospheric particulate matter in a small urban center subjected to airborne emission from vehicle traffic and sugar cane burning.

Atmospheric particulate matter (PM) is genotoxic and recently was classified as carcinogenic to humans by the International Agency for Research on Cancer. PM chemical composition varies depending on source and atmospheric conditions. The Salmonella/microsome assay is the most used mutagenicity test and can identify the major chemical classes responsible for observed mutagenicity. The objective of this work was to characterize the mutagenicity of PM samples from a countryside city, Limeira, Brazil, which is influenced by heavy traffic and sugar cane biomass burning. Six samples of total PM were collected. Air mass backward trajectories were calculated. Organic extracts were assayed using the Salmonella/microsome microsuspension mutagenicity assay using TA98, YG1041, and TA1538, with and without metabolic activation (S9). YG1041 was the most sensitive strain and mutagenicity reached 9,700 revertants per m(3) without metabolic activation. Potency for TA1538 was higher than TA98, indicating that this strain should be considered in air mutagenicity studies. The increased response to YG1041 relative to TA98, and the decreased response with S9, suggests that nitroaromatics are the major contributors. Limeira is among the most mutagenic cities in the world. High mutagenicity in Limeira seems to occur when the air mass from the area of sugarcane production is mixed with air from the region impacted by anthropogenic activities such as traffic. An increase in the formation of nitro-polycyclic aromatic hydrocarbons may result from longer contact time between the aromatic compounds and the atmosphere with high NOx and ozone concentration, although more studies are required to confirm this hypothesis.

Toxic Metal Concentrations in Mainstream Smoke from Cigarettes Available in the USA

Public health officials and leaders of 168 nations have signaled their concern regarding the health and economic impacts of smoking by becoming signatory parties to the World Health Organization Framework Convention on Tobacco Control (FCTC). One of FCTC's purposes is to help achieve meaningful regulation for tobacco products in order to decrease the exposure to harmful and potentially harmful constituents (HPHCs) delivered to users and those who are exposed to secondhand smoke. Determining baseline delivery ranges for HPHCs in modern commercial tobacco products is crucial information regulators could use to make informed decisions. Establishing mainstream smoke delivery concentration ranges for toxic metals was conducted through analyses of total particulate matter (TPM) collected with smoking machines using standard smoking regimens. We developed a rapid analytical method with microwave digestion of TPM samples obtained with smoking machines using electrostatic precipitation under the ISO and Intense smoking regimens. Digested samples are analyzed for chromium, manganese, cobalt, nickel, arsenic, cadmium and lead using inductively coupled plasma-mass spectrometry. This method provides data obtained using the ISO smoking regimen for comparability with previous studies as well as an Intense smoking regimen that represents deliveries that fall within the range of human exposure levels to toxic metals.

Effect of Cigarette Menthol Content on Mainstream Smoke Emissions

The 2009 Family Smoking Prevention and Tobacco Control Act empowered the U.S. Food and Drug Administration to study "the impact of the use of menthol in cigarettes on the public health, including such use among children, African Americans, Hispanics and other racial and ethnic minorities," and develop recommendations. Current scientific evidence comparing human exposures between menthol and nonmenthol smokers shows mixed results. This is largely because of the many differences between commercial menthol and nonmenthol cigarettes other than their menthol content. We conducted an innovative study using two types of test cigarettes: a commercial nonmenthol brand that we mentholated at four different levels, and Camel Crush, a commercial cigarette containing a small capsule in the filter that releases menthol solution into the filter when crushed. Cigarettes were machine-smoked at each of the menthol levels investigated, and the total particulate matter (TPM) was collected on a quartz fiber filter pad and analyzed by gas chromatography/mass spectrometry for menthol, nicotine, tobacco-specific nitrosamines (TSNAs), polycyclic aromatic hydrocarbons (PAHs), cotinine, and quinoline. The mainstream smoke was also monitored continuously in real time on a puff-by-puff basis for seven gas-phase constituents (acetaldehyde, acetonitrile, acrylonitrile, benzene, 1,3-butadiene, isoprene, and 2,5-dimethylfuran), using a proton transfer reaction-mass spectrometer. Average yields (in micrograms/cigarette) for the analytes were determined. Menthol in the TPM samples increased linearly with applied menthol concentration, but the amounts of nicotine along with the target TSNAs, PAHs, cotinine, and quinoline in the cigarettes remained essentially unchanged. Similarly, yields of the targeted volatile organic compounds (VOCs) in whole smoke from the mentholated nonmenthol cigarettes that were measured in real-time were largely unaffected by their menthol levels. In the Camel Crush cigarettes, however, the VOC yields appeared to increase in the presence of menthol, especially in the gas phase. Although we succeeded in characterizing key mainstream smoke constituents in cigarettes that differ only in menthol content, further study is needed to definitively answer whether menthol affects exposure to selected cigarette constituents and thereby influences harm.

Synergistic use of several receptor models (CMB, APCS and PMF) to interpret air quality data

AbstractPM10 samples were collected in Civitavecchia (Rome, Italy) during a monitoring campaign performed between August and September 2008; elemental, ionic and organic characterisation of the samples was carried out. Three receptor models (Chemical Mass Balance, Absolute Principal Component Scores and Positive Matrix Factorisation) were applied to identify PM10 sources and their contributions. The results obtained by the models were compared in order to perform a robust characterisation of the sources.Seven emission sources were considered relevant for the area under investigation and their profiles were used to run CMB. Source percentage contributions to the total particulate matter samples were evaluated: the greater contribution was obtained for Traffic (39%), the lower for Marine Aerosol (3%).Five factors were selected to perform the multivariate receptor models (APCS and PMF) after the application of explorative Principal Component Analysis to the dataset. Furthermore, attention was focused on the characterisation of source profiles and contributions obtained by PMF because it best reconstructed the PM mass of the samples.The percentage contributions of the five sources to the total PM samples were estimated: the greater contribution was obtained for resuspended matter (22%), the lower for combustions (17%).The results of the source apportionment studies can be used by air quality managers to develop appropriate control strategy. However, the differences in sources profiles and weights obtained by the models were related to their specific approaches: further investigations are suggested in order to develop sources profiles more reliable for the area under investigation. Copyright © 2011 John Wiley &amp; Sons, Ltd.

DETERMINATION OF TRACE METALS DUE TO THE PRODUCTION AND USE OF DIESEL THROUGH THE AIR QUALITY MONITORING OF IMPACTED AREAS

The petroleum industry has difficulties to assess the trace metal content in liquid fuels. In this work, it is proposed to solve this problem determining these metals by collecting particulate matter atmospheric samples and analysing their metal content. Samples of total particulate matter and of inhalable particles (PM10) were collected in a bus station in the period August 2006-February 2007. The only significant emission source in that location are the buses, fueled by diesel, since light duty vehicles account for about 1-2% of the total vehicular flux and no other activities are developed in the area. Metal levels were determined by ICP-OES (Inductively Coupled Plasma Optical Emission Spectroscopy). Ca, Mg, Fe and Al were the most abundant compounds, and account for about 50.1%, 24.2%, 6.5% and 18.7%, respectively, of the metal contain. Co, Ni, Cd, Cr and Pb were under their detection limits, except for a few samples. Ca, Mg, Zn and Cu were determined in higher ratios that those currently find in crustal materials indicating that these elements may have important combustion sources and are enriched in the soil.

In vitro bioactivity of combustion products from 12 tobacco constituents

Twelve chemical components of tobacco leaf, representing 50% of its dry weight, were individually combusted and the bioactivities of their combustion products i.e. total particulate matter (TPM) were assayed using three in vitro tests. These components included carbohydrates, amino acids, proteins, polyphenols and carboxylic acids. The mutagenic potencies were assessed with the Salmonella mutagenicity assay ( S. typhimurium TA98 and TA100). The induction of chromosomal damage, determined with the micronucleus test (IVMNT), and the neutral red uptake cytotoxicity test (NRU), were conducted on V79 hamster lung fibroblast cells. The Salmonella mutagenicity test and IVMNT were conducted with and without rat liver microsomal S9 fraction. Salmonella mutagenicity data confirmed the mutagenicity of TPM samples obtained from nitrogenous compounds (amino acids and proteins). The IVMNT showed that precursors of phenols in smoke (i.e. polyphenols) exhibited significantly higher levels of toxicity compared to other tobacco components. While S9 activation amplified the Salmonella mutagenicity response to combustion products, it significantly inhibited the toxicity measured with the IVMNT. NRU data demonstrated the increasing cytotoxicity induced following longer exposure time to TPM samples from nitrogenous and phenolic components. This study is the first to characterize the toxicity of the combustion products of major tobacco constituents. Our data suggest different mechanisms of toxicity and underline the relevance of using various bioassays.