Salient PM Research Articles

Analysis and Design of a Novel Doubly SalientPMMotor Based on Parallel Path Magnetic Technology

AbstractIn this paper, a novel doubly salient PM motor based on parallel path magnetic technology (PPMT) is presented. PPMT is an advanced magnetic control technology, which can be applied to linear and rotary actuators. First, the fundamental principle of the PPMT prototype is elaborated, and then a comprehensive research and analysis of PPMT motor is carried out, with particular emphasis on machine topology, operation principle and electromagnetic performance. The equivalent no‐load PM magnetic circuit model is established and equations for calculating the main PM flux are derived. Besides, a dual‐stator 6‐pole PPMT motor prototype has been developed to valid the analysis. According to the similarity of topology and operation principle, comparison between the FSPM machine and PPMT machine is conducted, which leads to the conclusion that the PPMT motor has lower cogging torque, lower torque ripple and better sine back EMF waveform, the PPMT motor is more suitable for servo applications compared to FSPM motor. Finally, to improve the power density of PPMT motor, FE parametric modeling method for designing the three coupled stator parameters, which are the PM width, the stator yoke width and the second airgap length is given out. © 2023 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC.

Do emotionally salient cues improve prospective memory performance in children and adolescents with autism?

BackgroundProspective memory (PM) describes the ability to initiate and perform a planned action after a delay. Previous studies suggest reduced PM in autism spectrum disorder (ASD); especially when tasks put high demands on executive control resources. Increasing cue salience by presenting emotional cues improves PM performance in non-autistic populations. AimsTo explore whether children with ASD, whose processing of emotionally connoted information might differ from that of typically developing children, may also benefit from this type of salience in PM tasks. Methods and proceduresTwenty-five children with and 25 children without ASD completed a 1-back ongoing task into which an event-based PM task was embedded. Emotional salience of PM cues was varied. Outcomes and resultsChildren with ASD performed as well as children without ASD on the PM task and equally benefited from emotionally salient cues. Specifically, negative cues increased PM performance compared to neutral cues in both groups Conclusions and implicationsThe findings are consistent with the multiprocess framework which postulates that salient PM cues increase performance by promoting automatic intention retrieval and reducing executive control demands. Children with ASD seem to show similar comprehension and accessibility to emotional cues as typically developing children.

Improved Stator/Rotor-Pole Number Combinations for Torque Ripple Reduction in Doubly Salient PM Machines

Doubly salient permanent magnet (DSPM) machines suffer from a large torque ripple due to unbalanced three phases, nonsinusoidal-phase back electromotive force, large cogging torque, etc. To suppress the torque ripple, this article proposes a new type of stator/rotor-pole number combinations. The number of stator poles is 18, while the number of rotor poles differs from the conventional counterpart (i.e., 12) by one. The DSPM machines with different stator/rotor-pole number combinations are globally optimized under the fixed copper loss and machine envelope. It shows that compared with the 18/12 stator/rotor-pole DSPM machine, the torque ripples of 18/11 and 18/13 stator/rotor-pole DSPM machines are reduced significantly, while their torque densities remain almost the same. An 18/13 stator/rotor-pole DSPM machine is built and tested so as to experimentally verify such improvement.

Principle and Analysis of Doubly Salient PM Motor With Π-Shaped Stator Iron Core Segments

This paper investigates a novel three-phase doubly salient permanent magnet (DSPM) motor. Because of the adoption of Π-shaped stator iron core segments, the asymmetrical magnetic circuit among different phases occurring in conventional DSPM motors with E-shaped stator iron core segments can be avoided, so that balanced and sinusoidal three-phase PM flux linkage and no-load electromotive force (EMF) can be achieved. First, based on a 12/7 stator/rotor pole combination, the operation principle of Π-core DSPM motor is discussed using the least magnetic reluctance principle. Then, the general airgap field modulation theory is extended to the Π-core DSPM motor for explaining its operation principle further and armature winding connection. The finite element analysis is used to validate theoretical analysis, as well as to calculate its electromagnetic performances. The results show that the 12/7-pole Π-core DSPM motor possesses higher average torque output capability and lower torque ripple compared with the 12/8-pole E-core counterpart. Finally, a 12/7-pole Π-core DSPM motor is built and tested so as to experimentally verify the theoretical analysis.

Acute stress shifts the balance between controlled and automatic processes in prospective memory

In everyday life we frequently rely on our abilities to postpone intentions until later occasions (prospective memory; PM) and to deactivate completed intentions even in stressful situations. Yet, little is known about the effects of acute stress on these abilities. In the present work we investigated the impact of acute stress on PM functioning under high task demands. (1) Different from previous studies, in which intention deactivation required mostly low processing demands, we used salient focal PM cues to induce high processing demands during intention-deactivation phases. (2) We systematically manipulated PM-monitoring demands in a nonfocal PM task that required participants to monitor for either one or six specific syllables that could occur in ongoing-task words. Eighty participants underwent the Trier Social Stress Test, a standardized stress induction protocol, or a standardized control situation, before performing a computerized PM task. Our primary interests were whether PM performance, PM-monitoring costs, aftereffects of completed intentions and/or commission-error risk would differ between stressed and non-stressed individuals and whether these effects would differ under varying task demands.Results revealed that PM performance and aftereffects of completed intentions during subsequent performance were not affected by acute stress induction, replicating previous findings. Under high demands on intention deactivation (focal condition), however, acute stress produced a nominal increase in erroneous PM responses after intention completion (commission errors). Most importantly, under high demands on PM monitoring (nonfocal condition), acute stress led to a substantial reduction in PM-monitoring costs. These findings support ideas of selective and demand-dependent effects of acute stress on cognitive functioning. Under high task demands, acute stress might induce a shift in processing strategy towards resource-saving behavior, which seems to increase the efficiency of PM performance (reduced monitoring costs), but might increase initial susceptibility to automatic response activation after intention completion.

A new stator-flux orientation strategy for flux-switching permanent magnet motor based on current-hysteresis control

A stator-flux orientation strategy based on current hysteresis for the flux-switching permanent magnet (FSPM) motor is proposed, in which the stator-PM FSPM motor is considered as a conventional rotor-PM surface-mounted motor and an equivalent rotor-orientated dq-axes synchronous reference frame is built although there are actually no rotary magnetic motive force produced by the stator magnets in the FSPM motor. Based on the proposed model, a vector-control strategy with current hysteresis for the FSPM motor drive is investigated and implemented on a dSPACE-based platform, and both the simulated and experimental results validate the effectiveness. It should be emphasized that the proposed stator-flux orientation strategy can be applied to other stator-PM machines (including doubly salient and flux-reversal PM machines) and other control methods (including space-vector pulsed-width-modification and direct torque control).

Comparison of Stator-Permanent-Magnet Brushless Machines

This paper quantitatively compares two emerging stator-permanent-magnet (PM) machines, namely, the doubly salient PM and the PM hybrid brushless types. Both of them are attractive for electric vehicles and wind power generation. For comparison, both machines adopt the outer-rotor 36/24-pole topology and are designed based on the same peripheral dimensions. By using the circuit-field-torque time-stepping finite element analysis (CFT-TS-FEM), both steady-state and transient performances of the two machines are critically compared.

Industry application of zero-speed sensorless control techniques for PM synchronous motors

This paper presents the state of the art in the area of industrial applications of sensorless control for permanent-magnet synchronous motor (PMSM) drives. A new emerging technology is becoming mature to come to the market, based on high-frequency signal injection, that makes it possible to achieve zero-speed operation without increasing the complexity and the cost of the system. After an overview of major theoretical principles of sensorless control of PMSMs, the paper focuses on the practical implementation of one of the previously described high-frequency injection techniques in both salient and nonsalient PM machines. Experimental results are presented, including useful hints for practical implementation.