Objectives: Comparative evaluation of surface changes and bond strength of Microabrasion Bleached enamel before and after Remineralization with Nano-hydroxyapatite paste, an In vitro study. Methods: Enamel samples were divided into - Group I - Conventional bleaching (HB), Group II - Conventional bleaching with remineralization (HB+N-Hp), Group III - Microabrasion-assisted bleaching (M+HB), and Group IV - Microabrasion-assisted bleaching with remineralization (M+HB+N Hp). Surface roughness was measured using a profilometer. Samples were stored in artificial saliva for two weeks, then bonded with nanofilled composite resin and subjected to shear bond strength (SBS) analysis. Results: Group IV (M+HB+N-Hp) showed higher surface roughness than Groups I (HB) and II (HB+N-Hp), while Group II had significantly lower surface roughness compared to Groups III (M+HB) and IV. In terms of shear bond strength (SBS), Group III exhibited significantly higher SBS than Group I, whereas Group II showed significantly reduced SBS compared to Group I. All values were statistically significant. Conclusions: Remineralization with N-Hp reduces the surface roughness caused by bleaching and microabrasion, potentially decreasing bacterial biofilm adherence. Despite increased surface roughness correlating with better bond strength, microabrasion-assisted bleaching followed by remineralization and direct composite veneering after two weeks is a promising minimally invasive treatment for severe tooth discolorations. Further studies should explore varying frequencies and concentrations of N-Hp application.