Ricinoleic Methyl Ester Research Articles

Stability of mesoporous silica using ricinoleic methyl ester as a template with the addition of HCl and application of Cd2+ adsorption optimized by Box-Behnken design.

Mesoporous silica is restricted to organic solvents or other acidic media. The application of mesoporous silica depends on the medium's chemical stability and mechanical properties. It is necessary to stabilize the mesoporous silica material under acidic conditions. The results of the nitrogen adsorption characterization show that MS-50 has a large surface area and porosity, resulting in good mesoporous silica. Using variance analysis (ANOVA) to compare the collected data, the best conditions were found at a pH of 6.32, a Cd2+ concentration of 25.30 ppm, an adsorbent dose of 0.06 g, and a time of 70.44 min. The Cd2+ adsorption experiment data best fit the Langmuir isotherm model with the maximum amount of Cd2+ that MS-50 could absorb being 103.10 mg g-1.

METHANOL MASS VARIATION OF MESOPOROUS SILICA SYNTHESIS USING RICINOLEIC METHYL ESTER AS A TEMPLATE

This study aims to synthesize mesoporous silica using ricinoleic methyl ester as a template with the variation of methanol mass. Mesoporous silica was synthesized using ricinoleic methyl ester as a template, 3-aminopropyltrimethoxysilane as a structural directing agent, and tetraethyl orthosilicate (TEOS) as a source of silica. The novelty of this study lies in the use of ricinoleic methyl ester as a template. The reaction conditions were varied by varying the amount of methanol without adding hydrochloric acid 0.1M. The yield of mesoporous silica in samples named MSME A, MSME B, and MSME C was 1.63 g, 1.70 g, and 1.80 g. It shows that adding methanol mass affects the yield of mesoporous silica. Fourier-transform infrared spectroscopy (FTIR) analysis revealed that all silica products formed Si-O-Si bonds between 1103 cm-1 and 1111 cm-1 due to asymmetric stretching vibration. All silica products have a diffractogram at 2θ between 10o and 30o, indicating amorphous. The scanning electron microscope (SEM) image demonstrates the mesoporous silica morphology as a mixture of spherical particles and multiple sheets, fused round particles, aggregated particles, and spreading spherical particles. The BET analysis reveals a homogeneous pore size distribution in the third and fourth treatments. Each is dominated by a pore size range of 8.43 nm to 8.50 nm.

Stimulation of Wound Healing by Electroactive, Antibacterial, and Antioxidant Polyurethane/Siloxane Dressing Membranes: In Vitro and in Vivo Evaluations.

A series of novel polyurethane/siloxane-based wound dressing membranes was prepared through sol-gel reaction of methoxysilane end-functionalized urethane prepolymers composed of castor oil and ricinoleic methyl ester as well as methoxysilane functional aniline tetramer (AT) moieties. The samples were fully characterized and their physicochemical, mechanical, electrical, and biological properties were assayed. The biological activity of these dressings against fibroblast cells and couple of microbes was also studied. It was revealed that samples that displayed electroactivity by introduction of AT moieties showed a broad range of antimicrobial activity toward different microorganisms, promising antioxidant (radical scavenging) efficiency and significant activity for stimulation of fibroblast cell growth and proliferation. Meanwhile, these samples showed appropriate tensile strength and ability for maintaining a moist environment over a wound by controlled equilibrium water absorption and water vapor transmission rate. The selected electroactive dressing was subjected to an in vivo assay using a rat animal model and the wound healing process was monitored and compared with analogous dressing without AT moieties. The recorded results showed that the electroactive dressings induced an increase in the rate of wound contraction, promoted collagen deposition, and encouraged vascularization in the wounded area. On the basis of the results of in vitro and in vivo assays, the positive influence of designed dressings for accelerated healing of a wound model was confirmed.