Response Of Direct Torque Control Research Articles

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

This paper has proposed an efficient direct torque control strategy based on space vector modulation (SVM-DTC) for dual three-phase permanent magnet synchronous motor (DTP-PMSM), which is implemented in a synchronous reference frame aligned with the machine stator flux vector. This strategy adopts the space vector modulation technique to compensate for the stator flux error, and then the continuous smooth response of the vector control and the rapid response of direct torque control are both achieved. Simulation studies of a 3KW DTP-PMSM are carried out. Simulation results show the improvement of the torque response, decrease of the torque ripple, the higher steady performance and better flux waveform.

Research on Ripples Reduction of Flux Linkage and Torque for DTC

In order to reduce the ripples of flux linkage and torque for direct torque control (DTC) and ensure constant inverter switching frequency, permanent magnet synchronous motor (PMSM) DTC based on space vector modulation (SVM) and extended Kalman filter (EKF) is researched in the paper. Simulation results have shown that the inherent advantages of fast dynamic response of DTC are maintained, and flux linkage and torque ripples are effectively reduced. Speed is estimated accurately, and sensorless operation is realized.

Grey-Fuzzy Implementation of Direct Torque Control of Induction Machines

A system with fast torque response is very beneficial in applications where direct torque control (DTC) is highly desirable. The principle of DTC is to control machine torque and flux directly by selecting the switching states of inverter according to the errors of torque and flux; however, the response of direct torque control is slower during start-up and during change in load. Fuzzy control with grey prediction strategy is proposed for the implementation of DTC to improve its slow response. Moreover, it uses less sensors than the conventional method. Experimental implementation of the fuzzy logic controller and the grey predictor is carried out to verify the behavior of the controller. The controller is implemented with a single board computer that uses a TMS320C30 DSP.